An all-fiber amplification of highly chirped dissipative solitons (DSs) by stimulated Raman scattering in a standard passive fiber with continuous-wave pumping is demonstrated for the first time to our knowledge. DSs with a duration of 20 ps and a repetition rate of 15.6 MHz at a wavelength of 1275 nm are amplified by a pump wave at 1205 nm. On-off Raman gain dependence on the amplifier length and pump power, as well as the pumping configuration, are experimentally studied. Uniform amplification has been achieved with a net gain of 10 dB resulting in a pulse energy of 13 nJ at backward pumping. Further Raman amplification is limited by emerging the next Stokes component. The output pulses are compressed by a factor of 50 down to a duration of 400 fs. As a result, the peak power reached the level of 9 kW. The demonstrated scheme can be a simple and robust alternative to the widely used parametric amplification of chirped pulses outside the dopant amplification band, and the resulting pulses can be used in multiphoton microscopy and other applications.

Download full-text PDF

Source
http://dx.doi.org/10.1364/OL.505933DOI Listing

Publication Analysis

Top Keywords

all-fiber amplification
8
amplification highly
8
highly chirped
8
chirped dissipative
8
dissipative solitons
8
stimulated raman
8
raman scattering
8
amplification
5
solitons micron
4
micron stimulated
4

Similar Publications

Electronically Controlled Dual-Wavelength Switchable SRS Fiber Amplifier in the NIR-II Region for Multispectral Photoacoustic Microscopy.

Laser Photon Rev

October 2024

Harvard Medical School, Boston, MA 02114, USA; Wellman Center for Photomedicine, Massachusetts General Hospital, Boston, MA 02114, USA; Department of Cardiology, Erasmus Medical Center, Rotterdam GD3015, The Netherlands; Institute for Medical Engineering and Science, Massachusetts Institute of Technology, Cambridge, MA 02142, USA.

Photoacoustic microscopy (PAM) is a high-resolution and non-invasive imaging modality that provides optical absorption contrast. By employing dual- or multiple-wavelength excitation, PAM extends its capabilities to offer valuable spectroscopic information. To achieve efficient multispectral PAM imaging, an essential requirement is a light source characterized by a high repetition rate and switching rate, a ≈microjoule pulse energy, and a ≈nanosecond pulse duration.

View Article and Find Full Text PDF

Open-closed single-tube on-beam tuning-fork-enhanced fiber-optic photoacoustic spectroscopy.

Photoacoustics

October 2024

Wuhan National Laboratory for Optoelectronics (WNLO) and National Engineering Research Center of Next Generation Internet Access-system, School of Optical and Electronic Information, Huazhong University of Science and Technology, Wuhan 430074, China.

A proof-of-concept on-beam tuning-fork-enhanced photoacoustic sensor based on an open-closed single-tube acoustic-microresonator (AmR) was proposed and investigated for the first time, to the best of our knowledge. Due to the high acoustic amplification effect, the open-closed AmR improved the detection sensitivity by 54 times with respect to the bare tuning fork (TF). Compared to traditional dual-tube/single-tube on-beam spectrophone configuration, the developed approach significantly facilitates the laser beam alignment and reduces the sensor size and gas consumption.

View Article and Find Full Text PDF
Article Synopsis
  • Mode-division multiplexing (MDM) and wavelength-division multiplexing (WDM) are effective methods to increase the capacity of fiber-optic systems, requiring amplification techniques like distributed Raman amplifiers (DRA) for signal light enhancement.
  • This study showcases the successful transmission of 3 OAM modes and 9 WDM channels over a 104-km custom ring-core fiber using DRA to amplify the signals.
  • The developed mode selective couplers efficiently (de)multiplex OAM modes, while the OAM-DRA achieves high and flat gain, crucial for maintaining performance over long distances in the communication spectrum.
View Article and Find Full Text PDF

Multicore fibers are promising structures with specific light propagation properties, which can be managed to benefit several applications in optical communications, fiber lasers and amplifiers, high-resolution imaging, and fiber-based sensors. The current use of multicore fibers in laser technology is mainly focused on in-phase coherent beam combining in far-field regions (out-cavity) using bulk optical elements. However, this approach is challenging in terms of the power scalability of all-fiber lasers (intra-cavity), particularly with using low-gain media, where it is needed to provide mode-coupling (supermode propagation) stability along relatively long lengths.

View Article and Find Full Text PDF

A cost-effective fiber laser architecture is introduced in which the output seed pulse is stretched and then returned in the oscillator for an additional single-pass amplification without spectral broadening. It is implemented in an all-PM-fiber configuration based on a Mamyshev oscillator with a low repetition rate of 1 MHz. It features a linear oscillator bounded by two offset chirped fiber Bragg gratings accompanied by a third one acting as a pulse recycling filter.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!