Unraveling the influence of solvent composition on Drop-on-Demand binder jet 3D printed tablets containing calcium sulfate hemihydrate.

Recently, binder jet printed modular tablets were loaded with three anti-viral drugs via Drop on Demand (DoD) technology where drug solutions prepared in ethanol showed faster release than those prepared in water. During printing, water is used as a binding agent, whereas ethanol is added to maintain the porous structure of the tablets. Thus, the hypothesis is that the porosity would be controlled by manipulating the percentage of water and ethanol. In this study, Rhodamine 6G (R6G) was selected as a model drug due to its high solubility in water and ethanol, visualization function as a fluorescent dye, and potential therapeutic effects for cancer treatment. Approximately, 10 mg/ml R6G solutions were prepared with five different water-ethanol ratios (0-100, 75-25, 50-50, 75-25, 100-0). The ink solutions were printed onto blank binder jet 3D-printed tablets containing calcium sulphate hemihydrate using DoD technology. The tablets were dried at room temperature and then characterized using SEM-EDX, fluorescent microscope, TGA, XRD, FTIR, and DSC as well as in vitro release studies to investigate the impact of water-ethanol ratio on the release profile of R6G. Results indicated that the solution with higher ethanol ratio penetrated the tablets faster than the lower ethanol ratio, while the solution prepared with pure water was first accumulated onto the tablets' surface and then absorbed by the tablets. Moreover, tablets with more water content gained more weight and thickness. The EDX analysis and fluorescent microscope showed the uniform surface distribution of the drug. The SEM images revealed the difference in the tablet surface among the five formulations. Furthermore, the TGA data presents a notable increase in water loss, with XRD analysis suggesting the formation of gypsum in tablets containing elevated water content. The release study exhibited that the fastest release was from WE0-100, whereas the release rate decreases as the content of water increases. The WE0-100 releases more than 40 % drug within the first hour which is almost twice as high of the WE100-0 formulation. This DoD technology could distribute drugs onto the tablet's surface uniformly. The calcium sulfate would transform from hemihydrate to dihydrate form in the presence of water and therefore, those tablets treated with higher water content led to slower release. In conclusion, this study underscores the substantial impact of the water-ethanol ratio on drug release from binder jet printed tablets and highlights the potential of DoD technology for uniform drug distribution and controlled release.