Cementing techniques for total knee arthroplasty in Norwegian hospitals; a questionnaire-based study.

BMC Musculoskelet Disord

Department of Clinical Medicine, Faculty of Medicine, University of Bergen, Jonas Lies Vei 87, 5021, Bergen, Norway.

Published: November 2023

Background: Cementing technique in total knee arthroplasty (TKA) may influence implant survival. There is limited knowledge about the results with clinically used techniques. The aim of this study was to investigate cementing techniques for TKA in Norwegian hospitals, to compare widely used techniques to recommendations from the literature, and to investigate variation within hospitals.

Methods: A questionnaire requesting information about cementing techniques were distributed to all Norwegian orthopedic surgeons performing TKAs regularly in 2020. Data was analyzed using descriptive statistical methods.

Results: We acquired 121 responses out of 257 surgeons. They were from 45 out of 56 hospitals, and at least half of the TKA surgeons from 20 hospitals, constituting 79 surgeons. All responders used pulsatile lavage. Cement application to both the tibial plateau and stem (full cementation) was practiced by 61%. Application of cement to both implant and bone was done by 70% of surgeons. Techniques to improve cement penetration were used by 86%. Only 35% of surgeons aimed to get a cement mantle thickness between 3-5 mm. Flexing the knee joint to remove excess cement was done by 82%. We found that in 55% of 20 hospitals the surgeons did not agree on the use of common guidelines in their ward.

Conclusions: The majority of the responders used recommended techniques from the literature when cementing TKA. At more than half of the eligible hospitals, surgeons disagreed about their hospitals' use of common guidelines. Focusing on developing evidence-based guidelines would be beneficial for TKA-quality.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC10656824PMC
http://dx.doi.org/10.1186/s12891-023-07040-2DOI Listing

Publication Analysis

Top Keywords

cementing techniques
12
total knee
8
knee arthroplasty
8
norwegian hospitals
8
surgeons
8
surgeons hospitals
8
hospitals surgeons
8
common guidelines
8
hospitals
6
techniques
6

Similar Publications

Objective: This study evaluated dentin morphology and pulp cavity temperature changes during nanosecond‑ and microsecond‑pulse Er, Cr: YSGG laser debonding restoration and residual adhesive.

Materials And Methods: Ten caries-free teeth had their enamel removed perpendicular to the long axis, followed by bonding of glass ceramic restorations. The samples were randomly divided into two groups and subjected to Er, Cr: YSGG laser (3 mJ, 100 Hz, 100 ns), (3 mJ, 100 Hz, 150 µs) for debonding of restoration and residual adhesive on dentin surfaces.

View Article and Find Full Text PDF

Shear Strength of Adhesives Based on Solvent Type, Aged, and LED-cured with Different Wavelengths: An Study.

J Contemp Dent Pract

September 2024

Department of Academic, Faculty of Dentistry, Universidad Nacional Federico Villarreal, Lima, Peru, ORCID: https://orcid.org/0000-0002-0594-5834.

Objective: To evaluate the shear strength of adhesives based on the type of solvent (ethanol and acetone), aged and light-cured using light-emitting diode (LED) units with different wavelengths. Polywave and monowave LED units were employed for this study.

Materials And Methods: Ninety bovine tooth samples were analyzed using OptiBond Universal adhesive (acetone) and single bond universal adhesive (ethanol).

View Article and Find Full Text PDF

Aim: This study evaluates long-term shear bond strength (SBS) and enamel micro cracks (MCs) healing after using adhesive pre-coated brackets (APC).

Materials And Methods: A total of eighty extracted human premolar teeth were randomly divided into four experimental groups ( = 20 per group): Control group: Teeth underwent indentation but no bracket bonding; group II : Teeth were subjected to indentation without exposure to thermocycling; group III: Teeth experienced both indentation and thermocycling; group IV: No indentation was applied to the teeth; groups III and IV were further divided into two subgroups to simulate different clinical timelines: Subgroup A (n = 10): Teeth underwent 5,000 thermocycles, equivalent to six months of clinical use. Subgroup B (n = 10): Teeth were subjected to 10,000 thermocycles, representing 12 months of use.

View Article and Find Full Text PDF

Background: Despite multiple studies, less recent literature and data regarding the mortality associated with hip fractures in the elderly population are available.

Objectives: To assess the mortality data and functional outcomes of patients who underwent cemented and uncemented hemiarthroplasty in femoral neck fractures. To evaluate if preoperative (minimum 2 months) calcium and vitamin D supplement intake in patients affects postoperative mobilization with or without walker support.

View Article and Find Full Text PDF

Stem fixation techniques in revision total knee arthroplasty: A systematic review and meta-analysis.

J Exp Orthop

January 2025

Department of Orthopaedic Surgery and Traumatology Città della Salute e della Scienza Turin Italy.

Purpose: This systematic review and meta-analysis aimed to compare the clinical and radiological outcomes of patients undergoing revision total knee arthroplasty (rTKA) using uncemented press-fit stems (hybrid fixation) versus cemented stems (cemented fixation). It is also examined whether cemented fixation offers any superiority over hybrid fixation regarding implant survival, clinical function, imaging analysis and complication rates.

Methods: Following the PRISMA guidelines, a systematic review and meta-analysis were conducted on five databases (Pubmed, Scopus, Embase, Medline and Cochrane).

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!