Introduction: Smart devices are widely available and capable of quickly recording and uploading speech segments for health-related analysis. The switch from laboratory recordings with professional-grade microphone setups to remote, smart device-based recordings offers immense potential for the scalability of voice assessment. Yet, a growing body of literature points to a wide heterogeneity among acoustic metrics for their robustness to variation in recording devices. The addition of consumer-grade plug-and-play microphones has been proposed as a possible solution. The aim of our study was to assess if the addition of consumer-grade plug-and-play microphones increases the acoustic measurement agreement between ultra-portable devices and a reference microphone.

Methods: Speech was simultaneously recorded by a reference high-quality microphone commonly used in research and by two configurations with plug-and-play microphones. Twelve speech-acoustic features were calculated using recordings from each microphone to determine the agreement intervals in measurements between microphones. Agreement intervals were then compared to expected deviations in speech in various neurological conditions. Each microphone's response to speech and to silence was characterized through acoustic analysis to explore possible reasons for differences in acoustic measurements between microphones. The statistical differentiation of two groups, neurotypical and people with multiple sclerosis, using metrics from each tested microphone was compared to that of the reference microphone.

Results: The two consumer-grade plug-and-play microphones favored high frequencies (mean center of gravity difference ≥ +175.3 Hz) and recorded more noise (mean difference in signal to noise ≤ -4.2 dB) when compared to the reference microphone. Between consumer-grade microphones, differences in relative noise were closely related to distance between the microphone and the speaker's mouth. Agreement intervals between the reference and consumer-grade microphones remained under disease-expected deviations only for fundamental frequency (f0, agreement interval ≤0.06 Hz), f0 instability (f0 CoV, agreement interval ≤0.05%), and tracking of second formant movement (agreement interval ≤1.4 Hz/ms). Agreement between microphones was poor for other metrics, particularly for fine timing metrics (mean pause length and pause length variability for various tasks). The statistical difference between the two groups of speakers was smaller with the plug-and-play than with the reference microphone.

Conclusion: Measurement of f0 and F2 slope was robust to variation in recording equipment, while other acoustic metrics were not. Thus, the tested plug-and-play microphones should not be used interchangeably with professional-grade microphones for speech analysis. Plug-and-play microphones may assist in equipment standardization within speech studies, including remote or self-recording, possibly with small loss in accuracy and statistical power as observed in the current study.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC11309067PMC
http://dx.doi.org/10.1159/000535152DOI Listing

Publication Analysis

Top Keywords

plug-and-play microphones
28
consumer-grade plug-and-play
12
microphones
12
agreement intervals
12
agreement interval
12
plug-and-play
8
smart devices
8
acoustic metrics
8
variation recording
8
addition consumer-grade
8

Similar Publications

Current virtual reality (VR) system takes gesture interaction based on camera, handle and touch screen as one of the mainstream interaction methods, which can provide accurate gesture input for it. However, limited by application forms and the volume of devices, these methods cannot extend the interaction area to such surfaces as walls and tables. To address the above challenge, we propose AudioGest, a portable, plug-and-play system that detects the audio signal generated by finger tapping and sliding on the surface through a set of microphone devices without extensive calibration.

View Article and Find Full Text PDF

Introduction: Smart devices are widely available and capable of quickly recording and uploading speech segments for health-related analysis. The switch from laboratory recordings with professional-grade microphone setups to remote, smart device-based recordings offers immense potential for the scalability of voice assessment. Yet, a growing body of literature points to a wide heterogeneity among acoustic metrics for their robustness to variation in recording devices.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!