AI Article Synopsis
Article Abstract
Antimony triselenide (Sb Se ) has possessed excellent optoelectronic properties and has gained interest as a light-harvesting material for photovoltaic technology over the past several years. However, the severe interfacial and bulk recombination obviously contribute to significant carrier transport loss thus leading to the deterioration of power conversion efficiency (PCE). In this work, buried interface and heterojunction engineering are synergistically employed to regulate the film growth kinetic and optimize the band alignment. Through this approach, the orientation of the precursor films is successfully controlled, promoting the preferred orientational growth of the (hk1) of the Sb Se films. Besides, interfacial trap-assisted nonradiative recombination loss and heterojunction band alignment are successfully minimized and optimized. As a result, the champion device presents a PCE of 9.24% with short-circuit density (J ) and fill factor (FF) of 29.47 mA cm and 63.65%, respectively, representing the highest efficiency in sputtered-derived Sb Se solar cells. This work provides an insightful prescription for fabricating high-quality Sb Se thin film and enhancing the performance of Sb Se solar cells.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1002/adma.202308522 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Expression of concern: Optimized Cu-doping in ZnO electro-spun nanofibers for enhanced photovoltaic performance in perovskite solar cells and photocatalytic dye degradation.
RSC Adv
December 2024
School of Engineering and Technology, National Textile University Faisalabad Pakistan
Expression of concern for 'Optimized Cu-doping in ZnO electro-spun nanofibers for enhanced photovoltaic performance in perovskite solar cells and photocatalytic dye degradation' by Kang Hoon Lee , , 2024, , 15391-15407, https://doi.org/10.1039/D4RA01544D.
View Article and Find Full Text PDFBuried interface management toward high-performance perovskite solar cells.
Chem Sci
December 2024
Frontiers Science Center for Flexible Electronics (FSCFE), Institute of Flexible Electronics (IFE), Northwestern Polytechnical University Xi'an 710072 China
The interface between the perovskite layer and the electron transport layer is an extremely important factor that cannot be ignored in achieving high-performance perovskite photovoltaic technology. However, the void defects of the interface pose a serious challenge for high performance perovskite solar cells (PSCs). To address this, we report a polydentate ligand reinforced chelating strategy to strengthen the stability of the buried interface by managing interfacial defects and stress.
View Article and Find Full Text PDFLead-Free Perovskite CsAgNaBiInCl Microcrystals for Scattering-Fluorescent Luminescent Solar Concentrators.
ACS Appl Mater Interfaces
December 2024
Institute of Materials for Electronics and Energy Technology (i-MEET), Department of Materials Science and Engineering, Friedrich-Alexander-Universität Erlangen-Nürnberg, Martensstrasse 7, Erlangen 91058, Germany.
In recent years, luminescent solar concentrators (LSCs) have gained a renaissance as a pivotal transparent photovoltaic (PV) for building-integrated photovoltaics (BIPVs). However, most of the studies focused on light-selective LSCs, and less attention was paid to the utilization of the full solar spectrum. In this study, a lead-free microcrystal CsAgNaBiInCl (CANBIC) perovskite phosphor is demonstrated to have bifunctional effects of luminescent down-shifting (LDS) and light scattering for the fabrication of LSCs, realizing light response from ultraviolet (UV) to NIR regions by an edge-mounted Si solar cell.
View Article and Find Full Text PDFCrosslinking-Driven Chemical Homogeneity Enhances Performance of Pre-Seeded Perovskite Solar Cells.
Small
December 2024
School of Materials and Energy, Yunnan University, Kunming, 650091, China.
Perovskite solar cells (PSCs) have achieved impressive efficiency, but their commercialization is limited by issues like chemical homogeneity within the perovskite films, leading to defects and phase segregation, which severely compromise the stability and performance of PSCs. This study presents a novel approach to overcoming these barriers by employing N,N-methylenebisacrylamide (MBA) as a multifunctional crosslinking agent within the perovskite structure. MBA enhances chemical uniformity both laterally and vertically, improves crystallinity, and boosts overall film stability by forming a robust crosslinked network that regulates nucleation and growth dynamics during the pre-seeding process.
View Article and Find Full Text PDFModulating Acceptor Phase Leads to 19.59% Efficiency Organic Solar Cells.
Adv Sci (Weinh)
December 2024
Center on Nanoenergy Research, Carbon Peak and Neutrality Science and Technology Development Institute, School of Physical Science & Technology, Guangxi University, Nanning, 530004, China.
Nonfullerene acceptors are critical in advancing the performance of organic solar cells. However, unfavorable morphology and low photon-to-electron conversion in the acceptor range continue to limit the photocurrent generation and overall device performance. Herein, benzoic anhydride, a low-cost polar molecule with excellent synergistic properties, is introduced in combination with the traditional additive 1-chloronaphthalene to optimize the aggregation of nonfullerene acceptors.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!