AC current shunts are used for precise current measurements. The application of AC current shunts requires that their amplitude phase characteristics are known. A group of three geometrically identical current shunts and a reference shunt are observed in this paper. The phase characteristics of the reference shunt have been previously obtained. A relative phase comparison has been made between the three geometrically identical shunts, and phase displacement values for each have been obtained. After this, the results are verified with the reference shunt. The relative method is most suitable for shunts, where their respective and values are small (compared with 1/ω) and of the same order. The ratios of the nominal resistance values of the shunts used in this paper are at the limit of the given statement. The conclusion is that the method applied at the mentioned limits, in terms of the metrology-grade phase angle determination of current shunts, is not to be considered reliable at frequencies higher than 1 kHz.
Download full-text PDF |
Source |
|---|---|
| http://www.ncbi.nlm.nih.gov/pmc/articles/PMC10610849 | PMC |
| http://dx.doi.org/10.3390/s23208510 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Activating waitlists: Identifying barriers and facilitators to pain self-management while waiting.
Br J Pain
January 2025
School of Psychology and Clinical Language Sciences, University of Reading, Reading, UK.
Objectives: Waitlists for pain management services are often extensive, risking psychological and physical decline and patient non-engagement in treatment once accessed. Currently, for outpatient pain management, no standardised waiting list interventions exist, resulting in passive waiting. To arrest prospective wait-related decline(s), this study aimed to identify the barriers and facilitators to pain self-management while waiting, forming the foundation for a waitlist intervention development.
View Article and Find Full Text PDFA universal high voltage SF6 circuit breaker for HVDC and HVAC systems.
Sci Rep
January 2025
Department of Electrical Engineering, Faculty of Engineering at Shoubra, Benha University, Cairo, 11629, Egypt.
High voltage alternating current (HVAC) and high voltage direct current (HVDC) transmission systems have acted as the pillars for the transmission field in power networks. Thus, two types of circuit breakers (CBs) existed; HVDC-CB and HVAC-CB. This imposed a burden on manufacturers by requiring them to set up a separate production line for each type of them, increasing production time and overall cost.
View Article and Find Full Text PDFEnd-procedural adherence to recommended hemodynamic targets does not improve the outcome of elective tips in cirrhotic patients.
Hepatology
January 2025
Department of Experimental and Clinical Medicine, University of Florence, Florence, Italy.
Background Aims: In clinical practice, the reduction of porto-caval pressure gradient (PCPG) following trans-jugular intra-hepatic porto-systemic shunt (TIPS) does not always meet the recommendation of current guidance. We evaluated the impact of different degrees of PCPG reduction, measured at the end of an elective TIPS, on ascites control, recurrence of portal hypertension-related bleeding (PHRB) and survival.
Approach And Results: Cirrhotic patients receiving TIPS for refractory ascites (RA) or for the secondary prophylaxis of PHRB were consecutively enrolled.
Numerical Investigation and Device Architecture Optimization of SbSe Thin-Film Solar Cells Using SCAPS-1D.
Materials (Basel)
December 2024
Department of Mechatronics Engineering, National Changhua University of Education, Changhua 50007, Taiwan.
Antimony selenide (SbSe) shows promise for photovoltaics due to its favorable properties and low toxicity. However, current SbSe solar cells exhibit efficiencies significantly below their theoretical limits, primarily due to interface recombination and non-optimal device architectures. This study presents a comprehensive numerical investigation of SbSe thin-film solar cells using SCAPS-1D simulation software, focusing on device architecture optimization and interface engineering.
View Article and Find Full Text PDFDesign and numerical simulation of CuBiO solar cells with graphene quantum dots as hole transport layer under ideal and non-ideal conditions.
Sci Rep
January 2025
Department of Sciences, Indian Institute of Information Technology Design and Manufacturing Kurnool, Kurnool, Andhra Pradesh, 518008, India.
The simulation of ideal and non-ideal conditions using the SCAPS-1D simulator for novel structure Ag/FTO/CuBiO/GQD/Au was done for the first time. The recombination of charge carriers in CuBiO is an inherent problem due to very low hole mobility and polaron transport in the valence band. The in-depth analysis of the simulation result revealed that Graphene Quantum Dots (GQDs) can act as an appropriate hole transport layer (HTL) and can enhance hole transportation.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!