Viologens are fascinating redox-active organic compounds that have been widely explored in electrochromic devices (ECDs). However, the combination of electrochromic and resistive random-access memory in a single viologen remains unexplored. We report the coexistence of bistate electrochromic and single-resistor (1R) memory functions in a novel viologen. A high-performance electrochromic function is achieved by combining viologen (BzV2PF) with polythiophene (P3HT), enabling a "push-pull" electronic effect due to the efficient intermolecular charge transfer in response to an applied bias. The ECDs show high coloration efficiency (ca. 1150 ± 10 cm C), subsecond switching time, good cycle stability (>10 switching cycles), and low-bias operation (±1.5 V). The ECDs require low power for switching the color states (55 μW cm for magenta and 141 μW cm for blue color). The random-access memory devices (p-Si/BzV2PF/Al) exhibit distinct low and high resistive states with an ON/OFF ratio of ∼10, bipolar and nonvolatile characteristics that manifest good performances, and "Write"-"Read"-"Erase" (WRE) functions. The charge conduction mechanism of the RRAM device is elucidated by the Poole-Frenkel model where SET and RESET states arise at a low transition voltage ( = ±1.7 V). Device statistics and performance parameters for both electrochromic and memory devices are compared with the literature data. Our findings on electrochromism and nonvolatile memory originated in the same viologen could boost the development of multifunctional, smart, wearable, flexible, and low-cost optoelectronic devices.

Download full-text PDF

Source
http://dx.doi.org/10.1021/acsami.3c12489DOI Listing

Publication Analysis

Top Keywords

bipolar nonvolatile
8
nonvolatile memory
8
memory single
8
single viologen
8
random-access memory
8
memory devices
8
memory
6
viologen
5
electrochromic
5
coexistence electrochromism
4

Similar Publications

A highly effective method for creating a supramolecular metallogel of Ni(II) ions (NiA-TA) has been developed in our work. This approach uses benzene-1,3,5-tricarboxylic acid as a low molecular weight gelator (LMWG) in DMF solvent. Rheological studies assessed the mechanical properties of the Ni(II)-metallogel, revealing its angular frequency response and thixotropic behaviour.

View Article and Find Full Text PDF

Facile Hydrothermal Synthesis and Resistive Switching Mechanism of the α-FeO Memristor.

Molecules

November 2024

Wuhan National Laboratory for Optoelectronics, School of Optical and Electronic Information, Huazhong University of Science and Technology, Wuhan 430074, China.

Among the transition metal oxides, hematite (α-FeO) has been widely used in the preparation of memristors because of its excellent physical and chemical properties. In this paper, α-FeO nanowire arrays with a preferred orientation along the [110] direction were prepared by a facile hydrothermal method and annealing treatment on the FTO substrate, and then α-FeO nanowire array-based Au/α-FeO/FTO memristors were obtained by plating the Au electrodes on the as-prepared α-FeO nanowire arrays. The as-prepared α-FeO nanowire array-based Au/α-FeO/FTO memristors have demonstrated stable nonvolatile bipolar resistive switching behaviors with a high resistive switching ratio of about two orders of magnitude, good resistance retention (up to 10 s), and ultralow set voltage (V = +2.

View Article and Find Full Text PDF

Strain engineering provides an attractive approach to enhance device performance by modulating the intrinsic electrical properties of materials. This is especially applicable to 2D materials, which exhibit high sensitivity to mechanical stress. However, conventional methods, such as using polymer substrates, to apply strain have limitations in that the strain is temporary and global.

View Article and Find Full Text PDF

Non-volatile memristors dynamically switch between high (HRS) and low resistance states (LRS) in response to electrical stimuli, essential for electronic memories, neuromorphic computing, and artificial intelligence. High-entropy Prussian blue analogs (HE-PBAs) are promising insertion-type battery materials due to their diverse composition, high structural integrity, and favorable ionic conductivity. This work proposes a non-volatile, bipolar memristor based on HE-PBA.

View Article and Find Full Text PDF

In this study, nonvolatile bipolar resistive switching and synaptic emulation behaviors are performed in an InGaP quantum dots (QDs)/HfO-based memristor device. First, the physical and chemical properties of InGaP QDs are investigated by high-resolution transmission electron microscopy and spectrophotometric analysis. Through comparative experiments, it is proven that the HfO layer improves the variations in resistive switching characteristics.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!