Objective: To compare patient satisfaction during surgery, postoperative pain and inflammation and quality of life between high-speed drilling with irrigation and low-speed drilling without irrigation for implant bed preparation.
Materials And Methods: Sixty-six posterior single edentulous patients were included in a randomized controlled clinical trial. Implant beds were created using high-speed drilling with irrigation (control group) or low-speed drilling without irrigation (test group). Patient satisfaction during surgery (in relation to drilling-time perception, vibration, pressure, noise, comfort, and drowning sensation) and postoperative pain and inflammation were evaluated using a 100-mm visual analogue scale (VAS)-based questionnaire. Quality of life was analyzed with a Likert scale (in relation to mouth opening, chewing, speaking, sleeping, daily routine, and job). The follow-up period was 7 days.
Results: Patient satisfaction in relation to drilling-time perception, vibration, pressure, and noise did not show statistically significant differences (p > .05). The highest scores of drowning sensation (p < .05) were correlated (moderate correlation (r = .57)) with lowest scores of comfort (p < .005). Both postoperative pain and inflammation means were significantly higher in the control group than in the test group. No significant differences in quality of life were observed during the postoperative period (p > .05).
Conclusion: Low-speed drilling without irrigation for single implant site preparation was more comfortable for patients than high-speed drilling with irrigation, due to the correlation between important drowning sensation and low perceived comfort. Postoperative pain and inflammation were lower for low-speed drilling without irrigation. Further studies are needed to validate or refute these results.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1111/clr.14189 | DOI Listing |
Neurospine
December 2024
Department of Orthopedics, Chulabhorn Hospital, Bangkok, Thailand.
This surgical video demonstrates the full-endoscopic repair of an incidental durotomy, offering practical guidance and insights into the technique. Incidental dural tears occur in up to 1% of lumbar endoscopic surgeries, with risk factors including interlaminar approaches, stenosis decompression, and power drill usage. Although many dural tears are managed with sealant or gel foam, no standard exists for when surgical repair is necessary.
View Article and Find Full Text PDFSensors (Basel)
November 2024
Centro de Investigaciones Científicas y Tecnológicas de Extremadura (CICYTEX), Finca La Orden, Regional Government of Extremadura, Highway A-V, Km 372, 06187 Guadajira, Badajoz, Spain.
Reliable soil moisture information is essential for accurate irrigation scheduling. A wide range of soil moisture sensors are currently available on the market, but their performance needs to be evaluated as most sensors are calibrated under limited laboratory conditions. The aim of this study was to evaluate the performance of six commercially available moisture sensors (HydraProbe, Teros 10, Teros 11, EnviroPro, CS616 and Drill & Drop) and three tensiometers (Irrometer RSU-C-34, Teros 32 and Teros 21) and to establish calibration equations for a typical sandy soil of the Doñana National Park (Huelva, Spain).
View Article and Find Full Text PDFMaterials (Basel)
November 2024
Department of Life, Health and Environmental Sciences, University of L'Aquila, 67100 L'Aquila, Italy.
Drilling for implant site preparation generates heat, which can cause bone necrosis if temperatures exceed 47 °C for over a minute. Factors influencing heat include drill size, speed, pressure, irrigation, and tool wear. Frequent drill replacement is essential, as wear from repeated use and sterilization affects performance.
View Article and Find Full Text PDFJ Conserv Dent Endod
October 2024
Department of Conservative Dentistry and Endodontics, Krishnadevaraya College of Dental Sciences and Hospital, Bengaluru, Karnataka, India.
Guided endodontics has proven effective in treating pulp canal obliteration (PCO). However, challenges arise when dealing with limited vertical space, particularly in cases where long burs and guides are necessary. In this case report, we introduce a novel approach utilizing a sleeveless three-dimensional (3D)-printed guide, aimed at overcoming vertical space constraints while maintaining visibility and irrigation during drilling.
View Article and Find Full Text PDFOper Orthop Traumatol
November 2024
Klinik für Kinderchirurgie, Klinikum Dritter Orden, München, Deutschland.
Objective: The surgical goal is the arthroscopically assisted, closed reduction, and suture osteosynthesis of fractures of the tibial eminence in children and adolescents.
Indications: Fractures of the tibial eminence type (II)-III according to Meyers & McKeever or type IV according to Zaricznyj.
Contraindications: Fracture of the tibial eminence type I, conservatively treatable fracture type II according to Meyers & McKeever and ligamentous rupture of the anterior cruciate ligament.
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!