Nitrogen removal and nitrous oxide emission in the partial nitritation/anammox process at different reflux ratios.

Sci Total Environ

Beijing International Scientific and Technological Cooperation Base of Water Pollution Control Techniques for Antibiotics and Resistance Genes, Beijing Key Laboratory of Aqueous Typical Pollutants Control and Water Quality Safeguard, School of Environment, Beijing Jiaotong University, Beijing 100044, PR China.

Published: January 2024

The partial nitritation/anammox (PN/A) process has been widely used in wastewater treatment owing to its notable advantages, including a low aeration rate and the non-requirement of an additional carbon source. In practical implementation, nitrite accumulation affects the nitrogen-removal efficiency and the amount of NO released during the PN/A process. By implementing wastewater reflux, the nitrite concentration can be decreased, thereby achieving a balance between the nitrogen-removal efficiency and NO release. This study conducted the CANON process with varying reflux ratios of 0 to 300 % and ~300 mg/L ammonium in the influent. The highest removal efficiency of ammonium and total nitrogen (98.2 ± 0.8 and 77.8 ± 2.3 %, respectively) could be achieved at a reflux ratio of 200 %. Further, a reflux ratio of 200 % led to the lowest NO emission factor (2.21 %), with a 31.74 % reduction in NO emission compared to the process without refluxing. Additionally, the reactor at a reflux ratio of 200 % presented the highest relative abundance of anaerobic ammonium-oxidizing bacteria (30.98 %) and the lowest proportion of ammonium-oxidizing bacteria (9.57 %). This study aimed to elucidate the impact of the reflux ratio on the nitrogen-removal efficiency of the CANON process and to theoretically explain the influence of different reflux ratios on NO release. These findings provide a theoretical framework for enhancing the nitrogen-removal efficiency and mitigating carbon emissions in practical applications of the CANON process.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.scitotenv.2023.167520DOI Listing

Publication Analysis

Top Keywords

nitrogen-removal efficiency
16
reflux ratio
16
reflux ratios
12
canon process
12
ratio 200 %
12
partial nitritation/anammox
8
reflux
8
pn/a process
8
ammonium-oxidizing bacteria
8
process
7

Similar Publications

Thiocyanate (SCN) is a highly toxic reducing inorganic compound commonly found in various nitrogen-rich wastewater and is also a promising electron donor for mixotrophic denitrification. However, its extent of involvement in mixotrophic denitrification under conditions of carbon limitation or excess remains unclear. In this study, five reactors were constructed to investigate the participation and microbial mechanisms of SCN in mixotrophic denitrification under high C/N and low C/N conditions.

View Article and Find Full Text PDF

Insight into enhanced adaptability of iron-carbon biofilter in treating low-carbon nitrogen mariculture wastewater for nitrogen removal and carbon reduction.

Bioresour Technol

January 2025

Collaborative Innovation Center of Atmospheric Environment and Equipment Technology, Jiangsu Key Laboratory of Atmospheric Environment Monitoring and Pollution Control, School of Environmental Science and Engineering, Nanjing University of Information Science & Technology, Nanjing 210044 China. Electronic address:

Iron-carbon (Fe-C) based biofilters have shown significant advantages in treating mariculture wastewater by facilitating the mixotrophic heterotrophic nitrification-aerobic denitrification (HNAD) process. However, the effects of Fe-C materials and varying carbon-to-nitrogen (C/N) ratios on N removal and C reduction performance remain insufficiently explored. This study demonstrated that the Fe-C biofilter (R-Fe) achieved significantly higher NO-N removal efficiency (65.

View Article and Find Full Text PDF

Iron-based constructed wetlands (ICWs) displayed great potential in deep nitrogen elimination for low-polluted wastewater. However, the unsatisfactory denitrification performance caused by the limited solubility and sluggish activity of iron substrates needs to be improved in an eco-effective manner. To fill this gap, the bioavailability of iron substrates (iron scraps) affected by wetland biomass-derived carbon materials with potential conductivity were explored.

View Article and Find Full Text PDF

A new insight on simultaneous water purification and greenhouse gas reduction by constructing sulfur-siderite driven autotrophic denitrification pathways in constructed wetlands.

Water Res

January 2025

College of Chemistry, Chemical Engineering and Materials Science, Shandong Normal University, Jinan 250014, Shandong, China; Shandong Key Laboratory of Water Pollution Control and Resource Reuse, School of Environmental Science and Engineering, Shandong University, Qingdao 266237, Shandong, China. Electronic address:

Sulfur-siderite driven autotrophic denitrification (SSAD) has received increasing attention for nutrient removal in constructed wetlands (CWs). Nevertheless, its effectiveness in simultaneous water purification and greenhouse gases (GHGs) reduction remains obscure. In this study, three vertical flow constructed wetlands (VFCWs), filled with quartz sand (CCW), sulfur (S-CW), and sulfur-siderite mixed substrates (SS-CW), were constructed to investigate the underlying mechanisms of SSAD on water purification enhancement and GHGs reduction.

View Article and Find Full Text PDF

With the development of cities, the issue of excess nitrate in wastewater has become increasingly severe. Electrochemical technology has garnered significant attention due to its straightforward operation and environmental sustainability. A CoO/GF cathode was successfully prepared by depositing CoO onto Graphite felt (GF) using an electrochemical deposition-calcination method.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!