Preparation of Hybrid Films Based in Aluminum 8-Hydroxyquinoline as Organic Semiconductor for Photoconductor Applications.

Sensors (Basel)

Instituto de Investigaciones en Materiales, Universidad Nacional Autónoma de México, Circuito Exterior s/n. C.U., Mexico City 04510, Mexico.

Published: September 2023

In the present work, we have investigated an organic semiconductor based on tris(8-hydroxyquinoline) aluminum (AlQ) doped with tetracyanoquinodimethane (TCNQ), which can be used as an organic photoconductor. DFT calculations were carried out to optimize the structure of semiconductor species and to obtain related constants in order to compare experimental and theoretical results. Subsequently, AlQ-TCNQ films with polypyrrole (Ppy) matrix were fabricated, and they were morphologically and mechanically characterized by Scanning Electron Microscopy, X-ray diffraction and Atomic Force Microscopy techniques. The maximum stress for the film is 8.66 MPa, and the Knoop hardness is 0.0311. The optical behavior of the film was also analyzed, and the optical properties were found to exhibit two indirect transitions at 2.58 and 3.06 eV. Additionally, photoluminescence measurements were carried out and the film showed an intense visible emission in the visible region. Finally, a photoconductor was fabricated and electrically characterized. Applying a cubic spline approximation to fit cubic polynomials to the J-V curves, the ohmic to SCLC transition voltage VON and the trap-filled-limit voltage VTFL for the device were obtained. Then, the free carrier density and trap density for the device were approximated to n0=4.4586×10191m3 and Nt=3.1333×10311m3, respectively.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC10534926PMC
http://dx.doi.org/10.3390/s23187708DOI Listing

Publication Analysis

Top Keywords

organic semiconductor
8
preparation hybrid
4
hybrid films
4
films based
4
based aluminum
4
aluminum 8-hydroxyquinoline
4
8-hydroxyquinoline organic
4
semiconductor photoconductor
4
photoconductor applications
4
applications work
4

Similar Publications

The role of sulfidated zero-valent iron in enhancing anaerobic digestion of waste activated sludge.

J Environ Manage

January 2025

Guangdong Provincial Key Laboratory of Chemical Pollution and Environmental Safety & MOE Key Laboratory of Theoretical Chemistry of Environment, School of Environment, South China Normal University, Guangzhou, 510006, China; Institute of Science and Technology Innovation Co., Ltd., South China Normal University, Qingyuan, 511517, China. Electronic address:

Zero-valent iron (ZVI) has been confirmed in enhancing methane production by improving interspecies electron transfer during anaerobic digestion (AD) of waste activated sludge (WAS). In this study, we suppose that sulfidated zero-valent iron (S-ZVI), a semiconductor material, has better property of electron transfer in AD process. Based on two-phase anaerobic digestion process, nitrite and S-ZVI were used separately for improving acidogenic phase and methanogenic phase of anaerobic sludge digestion.

View Article and Find Full Text PDF

Physical vapor deposition is widely used in the fabrication of organic light-emitting diodes and has the potential to adjust the density and orientation through substrate temperature control, which may lead to enhanced electrical performance. However, it is unclear whether this enhanced property is because of the horizontal molecular orientation or the increased density. The effects of the density and orientation on the electrical properties of a potential electron transport material, (3-dibenzo[c,h]acridin-7-yl)phenyl)diphenylphosphine oxide (TPPO-dibenzacridine), were investigated.

View Article and Find Full Text PDF

To solve the energy crisis and environmental issues, it is essential to create effective and sustainable energy conversion and storage technologies. Traditional materials for energy conversion and storage however have several drawbacks, such as poor energy density and inadequate efficiency. The advantages of MOF-based materials, such as pristine MOFs, also known as porous coordination polymers, MOF composites, and their derivatives, over traditional materials, have been thoroughly investigated.

View Article and Find Full Text PDF

g-CN Modified with Metal Sulfides for Visible-Light-Driven Photocatalytic Degradation of Organic Pollutants.

Molecules

January 2025

Research Group of Environmental and Inorganic Photochemistry, Center for Natural Sciences, Faculty of Engineering, University of Pannonia, P.O. Box 158, H-8201 Veszprém, Hungary.

Graphitic carbon nitride (g-CN) proved to be a promising semiconductor for the photocatalytic degradation of various organic pollutants. However, its efficacy is limited by a fast electron hole recombination, a restricted quantity of active sites, and a modest absorption in the visible range. To overcome these limitations, g-CN-BiS and g-CN-ZnS composites were effectively produced utilizing a starch-assisted technique.

View Article and Find Full Text PDF

Dye-sensitization is a promising strategy to improve the light absorption and photoactivity abilities of wide-bandgap semiconductors, like TiO. For effective water-splitting photoanodes with no sacrificial agents, the electrochemical potential of the dye must exceed the thermodynamic threshold needed for the oxygen evolution reaction. This study investigates two promising organic cyanoacrylic dyes, designed to meet that criterion by means of theoretical calculations.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!