The electrophysiological response to rewards recorded during laboratory-based tasks has been well documented over the past two decades, yet little is known about the neural response patterns in 'real-world' settings. To address this issue, we combined a mobile-EEG system with an augmented reality headset (which blends high definition "holograms" within the real-world) to record event-related brain potentials (ERP) while participants navigated an operant chamber to find rewards. 25 participants (age = 18-43, Male=6, Female=19) were asked to choose between two floating holograms marking a west or east goal-location in a large room, and once participants reached the goal location, the hologram would turn into a reward (5 cents) or no-reward (0 cents) cue. Following the feedback cue, participants were required to return to a hologram marking the start location, and once standing in it, a 3 second counter hologram would initiate the next trial. This sequence was repeated until participants completed 200 trials. Consistent with previous research, reward feedback evoked the reward positivity, an ERP component believed to index the sensitivity of the anterior cingulate cortex to reward prediction error signals. The reward positivity peaked around 235ms post-feedback with a maximal at channel FCz (M=-2.60μV, SD=1.73μV) and was significantly different than zero (p < 0.01). At a behavioral level, participants took approximately 3.38 seconds to reach the goal-location and exhibited a general lose-shift (68.3% ± 3.5) response strategy and were slightly slower to return to the start location following negative feedback (2.43 sec) compared to positive feedback (2.38 sec), evidence of post-error slowing. Overall, these findings provide the first evidence that combining mobile-EEG with augmented reality technology is a feasible solution to enhance the ecological validity of human electrophysiological studies of goal-directed behavior and a step towards a new era of human cognitive neuroscience research that blurs the line between laboratory and reality.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC10491265 | PMC |
http://dx.doi.org/10.1101/2023.08.31.555757 | DOI Listing |
Sci Rep
January 2025
Department of Oral and Maxillofacial Surgery, University Hospitals Leuven, Leuven, Belgium.
This study aims to evaluate and compare the usability and performance of mixed reality (MR) technology versus conventional methods for preoperative planning of patient-specific reconstruction plates for orbital fractures. A crossover study design was used to compare MR technology with conventional three-dimensional (3D) printing approaches in the planning of maxillofacial traumatology treatments. The primary focus was on user-friendliness and the accuracy of patient-specific reconstruction planning.
View Article and Find Full Text PDFJ Ethn Subst Abuse
January 2025
Centre of Research Excellence: Indigenous Sovereignty & Smoking, Auckland, New Zealand.
Maternal smoking increases adverse risks for both the mother's pregnancy and the unborn child and remains disproportionately high among some Indigenous peoples. Decreasing smoking among pregnant Indigenous women has been identified as a health priority in New Zealand because of wide inequities in smoking-related harms. Using pre- and post-intervention questionnaires, this feasibility study assessed the acceptability and potential efficacy of a novel cessation program designed for Indigenous women by Indigenous experts utilizing traditional knowledge and practice.
View Article and Find Full Text PDFACS Appl Mater Interfaces
January 2025
Institute of High Pressure Physics, Polish Academy of Sciences, Warsaw 01-142, Poland.
Ultrasmall micro-light-emitting diodes (μLEDs), sized below 10 μm, are indispensable to create the next-generation augmented and virtual reality (AR/VR) devices. Their high brightness and low power consumption could not only enhance the user experience by providing vivid and lifelike visuals but also extend device longevity. However, a notable challenge emerges: a decrease in efficiency with a reduced size.
View Article and Find Full Text PDFJ Dent Sci
December 2024
Department of Oral and Maxillofacial Surgery, Faculty of Dentistry, Chulalongkorn University, Bangkok, Thailand.
Background/purpose: Computer-assisted implant surgery (CAIS) is increasingly performed to reduce deviations in implant position. Dynamic CAIS or navigation systems provide instant display of implant drilling instruments and patient positions directly on the computer monitor. Augmented reality (AR) technology allows operators to visualize real-time information projected onto the lenses of AR glasses.
View Article and Find Full Text PDFJ Dent Sci
December 2024
School of Dentistry, National Taiwan University, Taipei, Taiwan.
Integrating augmented reality (AR) and virtual reality (VR) into dental surgery education and practice has significantly advanced the precision and interactivity of dental training and patient care. This narrative review summarizes findings from extensive literature searches conducted in PubMed, Cochrane Library, and Embase, highlighting AR and VR technologies transformative impact and current applications. Research shows that AR improves surgical precision by offering real-time data overlays during procedures, leading to better outcomes in operations like dental implant placements.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!