Organic laser power converter for efficient wireless micro power transfer.

Nat Commun

State Key Laboratory of Polymer Physics and Chemistry, Beijing National Laboratory for Molecular Sciences, Institute of Chemistry, Chinese Academy of Sciences, Beijing, 100190, China.

Published: September 2023

Wireless power transfer with collimated power transmission and efficient conversion provides an alternative charging mode for off-grid and portable micro-power electronics. However, charging micro-power electronics with low photon flux can be challenging for current laser power converters. Here we show laser power converters with organic photovoltaic cells with good performance for application in laser wireless power transfer. The laser selection strategy is established and the upper limit of efficiency is proposed. The organic laser power converters exhibit a 36.2% efficiency at a 660 nm laser with a photon flux of 9.5 mW cm and achieve wireless micro power transfer with an output of 0.5 W on a 2 meter scale. This work shows the good performance of organic photovoltaic cells in constructing organic laser power converters and provides a potential solution for the wireless power transfer of micro-power electronics.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC10484967PMC
http://dx.doi.org/10.1038/s41467-023-41270-1DOI Listing

Publication Analysis

Top Keywords

laser power
20
power transfer
20
power converters
16
organic laser
12
wireless power
12
micro-power electronics
12
power
11
wireless micro
8
micro power
8
photon flux
8

Similar Publications

Installing photovoltaic systems (PVs) on building rooftops is a viable and sustainable alternative to meet the growing demand for electricity in cities. This work develops a methodology that uses LiDAR (laser imaging detection and ranging) technology and roof footprints to obtain a three-dimensional representation of the rooftops in the urban centre of Santa Isabel (Azuay, Ecuador). This allowed the determination of characteristics such as area, slope, orientation, and received solar radiation, making it possible to calculate the rooftop's theoretical, technical, and economic photovoltaic potential.

View Article and Find Full Text PDF

Convergent-beam attosecond x-ray crystallography.

Struct Dyn

January 2025

Center for Free-Electron Laser Science CFEL, Deutsches Elektronen-Synchrotron DESY, Notkestr. 85, 22607 Hamburg, Germany.

Sub-ångström spatial resolution of electron density coupled with sub-femtosecond to few-femtosecond temporal resolution is required to directly observe the dynamics of the electronic structure of a molecule after photoinitiation or some other ultrafast perturbation, such as by soft X-rays. Meeting this challenge, pushing the field of quantum crystallography to attosecond timescales, would bring insights into how the electronic and nuclear degrees of freedom couple, enable the study of quantum coherences involved in molecular dynamics, and ultimately enable these dynamics to be controlled. Here, we propose to reach this realm by employing convergent-beam x-ray crystallography with high-power attosecond pulses from a hard-x-ray free-electron laser.

View Article and Find Full Text PDF

Optical clocks require an ultra-stable laser to probe and precisely measure the frequency of the narrow-linewidth clock transition. We introduce a portable ultraviolet (UV) laser system for use in an aluminum quantum logic clock, demonstrating a fractional frequency instability of approximately mod   = 2 × 10. The system is based on an ultra-stable cavity with crystalline AlGaAs/GaAs mirror coatings, with a frequency quadrupling system employing two single-pass second-harmonic generation (SHG) stages.

View Article and Find Full Text PDF

In this Letter, we report an ultraflat high-power supercontinuum (SC) based on a low-loss short-length fluorotellurite fiber. A novel high-peak power dual-Raman soliton femtosecond laser is used as a pump source, which effectively extends the mid-infrared SC spectral range and enhances the flatness of the SC. Finally, we obtained a 10.

View Article and Find Full Text PDF

We developed a 915-nm pumped, passively Q-switched 976-nm ytterbium all-fiber laser with an average output power of 4.3 W. The laser utilizes a 16-cm Yb gain fiber, passively Q-switched by a 1.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!