Objective: The aim of this study was to evaluate the ability of 4-formylphenyl acrylate (FA) to enhance the bond strength and stabilize the resin-dentin bonding interface of universal adhesives in self-etching mode over time.
Methods: Different concentrations of FA (1%, 3%, 5%, 7%, 9%) were prepared as primer. The optimal group was selected according to degree of conversion of 2 universal adhesives (Single Bond Universal (SBU)/All-Bond Universal (ABU)), and grouped according to the pre-treatment time (30s, 1min, 2min). The micro-tensile strength before and after 10,000 times thermocycling aging was used to evaluate the bonding performance.
Results: The 1min application of FA (5%) increased the conversion rate of the adhesive. The expressions of microtensile bond strength and nanoleakage in the FA treatment group did not decrease significantly compared with their immediate values even after 10,000 thermocycling of aging. In situ zymography results showed that the hydrolytic activity of endogenous proteins decreased significantly in FA-1min group.
Conclusions: Treatment by FA primer can effectively enhance the bond stability at the bonding interface.
Clinical Relevance: FA can be used as a functional monomer in self-etching bonding system to dentin, which not only had high biocompatibility, but also can show good collagen cross-linking ability within clinically acceptable application time.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1016/j.jmbbm.2023.106087 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Bonding performance of universal adhesive systems to enamel - Effects of the acidic composition.
Dent Mater
December 2024
Graduate Program in Dentistry, School of Dentistry, Federal University of Rio Grande do Sul, Rua Ramiro Barcelos, Porto Alegre 2492, Brazil; Department of Conservative Dentistry, School of Dentistry, Federal University of Rio Grande do Sul, Rua Ramiro Barcelos, Porto Alegre 2492, Brazil. Electronic address:
Objectives: To evaluate the self-etch bonding potential of universal adhesive systems with varying acidic compositions by analyzing the wettability properties, topographical change, and microshear bond strength (µSBS) to enamel.
Methods: Eight universal adhesives were tested: All-Bond Universal (Bisco), Ambar Universal (FGM), Gluma Bond Universal (Kulzer), OptiBond Universal (Kerr), Peak Universal Bond (Ultradent), Prime&Bond Universal (Dentsply), Singlebond Universal (3 M ESPE), and Tetric N-Bond Universal (Ivoclar). Bovine incisors were prepared and treated with each adhesive according to the manufacturer's instructions.
Microcomputed tomography assessment of microleakage and void formation under ceramic adhesive precoated orthodontic brackets.
Am J Orthod Dentofacial Orthop
November 2024
Department of Orthodontics, Hamidiye Faculty of Dentistry, University of Health Sciences, Istanbul, Türkiye.
Introduction: This study aimed to evaluate microleakage, voids, and gaps in ceramic adhesive precoated (APC) brackets using microcomputed tomography and investigate their correlation with bond strength.
Methods: A total of 52 human premolars were included in this study. The teeth were randomly divided into 4 groups of 13 teeth each.
The Impact of Silver Diamine Fluoride and Potassium Iodide Treatment on Microtensile Bonds Strength of Composite Restoration for Carious Dentin in Primary and Permanent Teeth and Its Potential Color Changes: An In Vitro Study.
Eur J Dent
November 2024
Pediatric Dentistry & Public Health, Faculty of Dentistry, Sinai University, Kantara Campus, Ismailia, Egypt.
Objectives: This study aims to examine the effects of silver diamine fluoride and potassium iodide (SDF/KI) treatment on the possible color changes and the microtensile bond strength of composite restorations to carious dentin in different dentitions.
Material And Methods: A total of 48 sound human teeth were utilized in this study. Twenty-four primary molar teeth were divided into two groups.
Effectiveness of self-etching bonding systems on dentin after radiotherapy: perspectives on microtensile and microshear bond strength.
Clin Oral Investig
October 2024
Department of Operative Dentistry, Endodontics and Dental Materials, Bauru School of Dentistry, University of São Paulo, Bauru, SP, Brazil.
Objective: Self-etching dental adhesives bond with dentin through chemical reactions with calcium. This study assessed bond strength (BS) using microtensile (µTBS) and microshear (µSBS) tests on sound and post-radiotherapy dentin, with dental adhesives containing different functional monomers.
Methods: Sound dentin (SD) and post-radiotherapy irradiated dentin (ID) were tested with two adhesive systems: Clearfil SE Bond (SE, 10-MDP-based) and FL Bond II (FL, containing carboxylic and phosphonic monomers with S-PRG bioactive particles).
Resin cements are widely used to cement dental restorations; however, limited studies are available on the bond strength of these cements to computer-aided design/computer-aided manufacturing (CAD/CAM) base metal alloys. This study compared the shear bond strength between a self-etching resin cement (Panavia F 2.0) and a millable cobalt-chromium alloy (Ceramill Sintron) following various surface treatments.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!