Introduction: Inadequate spinal motion restriction in patients suffering from spinal injuries could lead to further neurological damage, ultimately worsening their prognosis. This study aimed to investigate the efficacy of long spinal boards (LSB), ske stretcher, and vacuum mattress for cervical spine immobilization during transportation of patients by measuring the angular motion of the cervical spine following lifting, transferring, and tilting.

Methods: We conducted an experimental study using a box of three randomizations and crossover designs without a washout period effect for the long spinal board, sked stretcher, and vacuum mattress. We concealed the randomization with sequentially numbered, opaque, sealed envelopes (SNOSE). Kinematic data were collected using eight optoelectronic cameras at 200 Hz (BTS Bioengineering, Milan, Italy) in triangular planes (lateral bending, flexion-extension, and axial rotation) while performing all three motions (static lift-hold, transfer, and 90° tilt).

Results: 12 cases (7 males and 5 females) with the mean age of 20 ± 3.03 (range: 18-28) years were studied. The three highest angular motions were observed in the axial rotation plane during patient's tilting under immobilization on all devices (Vacuum mattress having the highest value of 99.01±8.93, followed by the LSB at 89.89±34.35 and the sked stretcher at 86.30±7.73 degrees). During patient lifting, a higher angular motion was observed with vacuum mattress immobilization in flexion extension (Coefficient = 4.45; 95%CI: 0.46 - 8.45; p =0.029) and axial rotation (Coefficient = 3.70; 95%CI: 0.58 - 6.81; p =0.020) planes. During patient transfer, a higher angular motion was observed with sked stretcher in the flexion-extension plane (Coefficient = 2.98; 95%CI: 0.11 - 5.84; p = 0.042). During patient tilting to 90 degrees, a higher angular motion was observed with vacuum mattress immobilization in lateral bending (Coefficient = -4.08; 95%CI: -7.68 - -0.48; p = 0.026) for the vacuum mattress.

Conclusion: Based on the finding of the present study, patients on the vacuum mattress experience significantly higher angular motion in flexion extension and axial rotation during lifting, as well as lateral bending during 90-degree tilting. In addition, patients on the sked stretcher showed significantly higher angular motion in flexion-extension during the transferring. However, the predictive margins for immobilization across all devices did not demonstrate clinically significant differences among the three immobilization devices.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC10440752PMC
http://dx.doi.org/10.22037/aaem.v11i1.2036DOI Listing

Publication Analysis

Top Keywords

vacuum mattress
28
angular motion
24
sked stretcher
20
higher angular
20
axial rotation
16
long spinal
12
stretcher vacuum
12
cervical spine
12
lateral bending
12
immobilization devices
12

Similar Publications

Introduction: Animal bites can cause significant head and neck injuries in children with scalp avulsions posing a challenge. This report presents a case of successful partial-thickness skin grafting in managing a severe pediatric scalp avulsion from a dog bite.

Case Presentation: A 7-year-old boy who sustained extensive scalp injuries following a dog attack was admitted to the emergency room.

View Article and Find Full Text PDF

Background: Tomatoes are a significant product of the Mediterranean region and a crucial component of the Mediterranean diet. The formulation of dried tomato products enriched with proteins and bioactive compounds could be a strategic approach to promote adherence to the Mediterranean diet. Six different novel tomato products were analyzed using different protein enrichment sources (pea proteins and leaf proteins) and drying technologies (hot-air dryer, microwave vacuum dryer, and conventional dryer).

View Article and Find Full Text PDF
Article Synopsis
  • The significance of prehospital cervical spine immobilization in trauma patients is debated, especially due to potential negative effects like increased intracranial pressure, necessitating further research on the long-term use of rigid orthoses.
  • A study was conducted comparing cervical spine mobility when using a vacuum mattress with and without a rigid orthosis during simulated emergency transport in an ambulance.
  • Results showed statistically significant differences in biomechanical parameters, indicating that the use of a rigid orthosis may impact cervical spine movement during transport, but further investigation is needed to draw firm conclusions.
View Article and Find Full Text PDF

Background: The assessment of cervical spine motion is critical for out-of-hospital patients who suffer traumatic spinal cord injuries, given the profound implications such injuries have on individual well-being and broader public health concerns. 3D Optoelectronic systems (BTS SmartDX) are standard devices for motion measurement, but their price, complexity, and size prevent them from being used outside of designated laboratories. This study was designed to evaluate the accuracy and reliability of an inertial measurement unit (IMU) in gauging cervical spine motion among healthy volunteers, using a 3D optoelectronic motion capture system as a reference.

View Article and Find Full Text PDF

A method for calculating vector forces at human-mattress interface during sleeping positions utilizing image registration.

Sci Rep

July 2024

Beijing Advanced Innovation Center for Biomedical Engineering, Key Laboratory for Biomechanics and Mechanobiology of Ministry of Education, School of Biological Science and Medical Engineering, Beihang University, Beijing, 100191, China.

The vector forces at the human-mattress interface are not only crucial for understanding the distribution of vertical and shear forces exerted on the human body during sleep but also serves as a significant input for biomechanical models of sleeping positions, whose accuracy determines the credibility of predicting musculoskeletal system loads. In this study, we introduce a novel method for calculating the interface vector forces. By recording indentations after supine and lateral positions using a vacuum mattress and 3D scanner, we utilize image registration techniques to align body pressure distribution with the mattress deformation scanning images, thereby calculating the vector force values for each unit area (36.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!