AI Article Synopsis

Article Abstract

We reveal a novel phenomenon observed after self-catalytic growth of GaAs nanowires (NWs) on Si(111) substrates treated with a Ga focused ion beam (FIB). Depending on the ion dose, NW arrays with various geometrical parameters can be obtained. A minor treatment of the substrate enables a slight increase in the surface density of NWs relative to an unmodified substrate area. As the ion dose is increased up to ∼0.1 pCm, the growth of GaAs NWs and nanocrystals is suppressed. However, a further increase in the ion dose stimulates the crystal growth leading to the formation of extremely thin NWs (39 ± 5 nm) with a remarkably high surface density of up to 15m. Resting upon an analysis of the surface structure before and after stages of ion-beam treatment, ultra-high vacuum annealing and NW growth, we propose a mechanism underlying the phenomenon observed. We assume that the chemical interaction between embedded Ga ions and a native Si oxide layer leads either to the enhancement of the passivation properties of the oxide layer within FIB-modified areas (at low and middle ion doses), or to the etching of the passivating oxide layer by excess Ga atoms, resulting in the formation of pores (at high ion doses). Due to this behavior, local fabrication of GaAs NW arrays with a diverse range of characteristics can be implemented on the same substrate. This approach opens a new way for self-catalytic growth of GaAs NWs.

Download full-text PDF

Source
http://dx.doi.org/10.1088/1361-6528/acee84DOI Listing

Publication Analysis

Top Keywords

growth gaas
12
ion dose
12
oxide layer
12
focused ion
8
ion beam
8
phenomenon observed
8
self-catalytic growth
8
surface density
8
gaas nws
8
ion doses
8

Similar Publications

Developing a reliable procedure for the growth of III-V nanowires (NW) on silicon (Si) substrates remains a significant challenge, as current methods rely on trial-and-error approaches with varying interpretations of critical process steps such as sample preparation, Au-Si alloy formation in the growth reactor, and nanowire alignment. Addressing these challenges is essential for enabling high-performance electronic and optoelectronic devices that combine the superior properties of III-V NW semiconductors with the well-established Si-based technology. Combining conventional scalable growth methods, such as Metalorganic Chemical Vapor Deposition (MOCVD) with in situ characterization using Environmental Transmission Electron Microscopy (ETEM-MOCVD) enables a deeper understanding of the growth dynamics, if that knowledge is transferable to the scalable processes.

View Article and Find Full Text PDF

Cuprous oxide (CuO) thin films were chemically deposited from a solution onto GaAs(100) and (111) substrates using a simple three-component solution at near-ambient temperatures (10-60 °C). Interestingly, a similar deposition onto various other substrates including Si(100), Si(111), glass, fluorine-doped tin oxide, InP, and quartz resulted in no film formation. Films deposited on both GaAs(100) and (111) were found alongside substantial etching of the substrates.

View Article and Find Full Text PDF

Electrochemical deposition of Ni on arrays of GaAs nanowires with n-type channels.

Nanotechnology

January 2025

Laboratory of micro- and nanoelectronics, Saint Petersburg Electrotechnical University 'LETI', Prof. Popova st. 5, 197022 St.Petersburg, Russia.

The processes of electrochemical deposition of Ni on vertically aligned GaAs nanowires (NWs) grown by molecular-beam epitaxy (MBE) using Au as a growth catalyst on n-type Si(111) substrates were studied. Based on the results of electrochemical deposition, it was concluded that during the MBE synthesis of NWs the self-induced formation of conductive channels can occur inside NWs, thereby forming quasi core-shell NWs. Depending on the length of the channel compare to the NW heights and the parameters of electrochemical deposition, the different hybrid metal-semiconductor nanostructures, such as Ni nanoparticles on GaAs NW side walls, Ni clusters on top ends of GaAs NWs, core-shell GaAs/Ni NWs, were obtained.

View Article and Find Full Text PDF

GaAs Solar Cells Grown Directly on V-Groove Si Substrates.

ACS Appl Mater Interfaces

January 2025

National Renewable Energy Laboratory, Golden, Colorado 80401, United States.

The direct epitaxial growth of high-quality III-V semiconductors on Si is a challenging materials science problem with a number of applications in optoelectronic devices, such as solar cells and on-chip lasers. We report the reduction of dislocation density in GaAs solar cells grown directly on nanopatterned V-groove Si substrates by metal-organic vapor-phase epitaxy. Starting from a template of GaP on V-groove Si, we achieved a low threading dislocation density (TDD) of 3 × 10 cm in the GaAs by performing thermal cycle annealing of the GaAs followed by growth of InGaAs dislocation filter layers.

View Article and Find Full Text PDF

Lead Catalyzed GaAs Nanowires Grown by Molecular Beam Epitaxy.

Nanomaterials (Basel)

November 2024

Faculty of Physics, St. Petersburg State University, Universitetskaya Emb. 13B, 199034 St. Petersburg, Russia.

This study investigates the growth of gallium arsenide nanowires, using lead as a catalyst. Typically, nanowires are grown through the vapor-solid-liquid mechanism, where a key factor is the reduction in the nucleation barrier beneath the catalyst droplet. Arsenic exhibits limited solubility in conventional catalysts; however, this research explores an alternative scenario in which lead serves as a solvent for arsenic, while gallium and lead are immiscible liquids.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!