The aerial crop dusting and spraying of fields with the phosphorothioate insecticide parathion in the late 1900s, significantly improved crop yields but resulted in high levels of occupational toxicity in handlers and agricultural workers, as well as cases of intentional self-harm poisoning, culminating in its banning in many western countries by early 2000s. However because of the low solubility and volatility of parathion, most available products were formulated using organic solvents e.g. xylene, to increase the efficacy of the aerosols and dusts. In the present study, the toxicity of parathion was assessed when formulated in an aqueous solvents (ethanol/PBS (1:9)), and delivered to macaques as an aerosol. Doses of 780 μg/kg and 1.56 mg/kg were delivered one day apart, using a modified nebulizer calculated to result in lung deposition of ∼480 μg/kg with a similar or larger amount being swallowed; these doses being similar to the estimated lethal oral dose 286ug/kg - 1.43 mg/kg of formulated parathion in humans. Surprisingly, this dose (a combined amount of ∼14 mg) caused only low AChE inhibition and moderate BChE inhibition with no clinical symptoms, indicating that the use of organic solvents may have previously played a critical role in the severity of parathion toxicity following inhalation exposure. In addition, unlike constitutively toxic OPs, which are highly toxic when inhaled, these results are consistent with the idea that phosphorothioate insecticides appear to be more intoxicating following oral than inhalation exposure. However, this still remains uncertain because the presence of organic solvents in the ingested parathion studies was not always known.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC10574261PMC
http://dx.doi.org/10.1016/j.cbi.2023.110635DOI Listing

Publication Analysis

Top Keywords

organic solvents
12
inhalation exposure
8
parathion
7
impact solvents
4
toxicity
4
solvents toxicity
4
toxicity banned
4
banned parathion
4
parathion insecticide
4
insecticide aerial
4

Similar Publications

The high performance of two-dimensional (2D) channel membranes is generally achieved by preparing ultrathin or forming short channels with less tortuous transport through self-assembly of small flakes, demonstrating potential for highly efficient water desalination and purification, gas and ion separation, and organic solvent waste treatment. Here, we report the construction of vertical channels in graphene oxide (GO) membrane based on a substrate template with asymmetric pores. The membranes achieved water permeance of 2647 L m h bar while still maintaining an ultrahigh rejection rate of 99.

View Article and Find Full Text PDF

α-Terpineol and 1,8-cineole are two important compounds in essential oils. This study developed an efficient method to recover α-terpineol from model oil (MO) based on association extraction by in situ formations of deep eutectic solvent (DES) between α-terpineol and some quaternary ammonium salts (QASs) by hydrogen-bond (HB) interaction. Such interaction could be broken almost completely by the introduction of water, due to the stronger HB interaction between water and QASs, which could release α-terpineol by liquid-liquid separation and save the organic solvents consumption.

View Article and Find Full Text PDF

From solubility to efficiency: Per- and polyfluoroalkyl substances (PFAS) regeneration from anion exchange resins.

Sci Total Environ

January 2025

Department of Civil and Environmental Engineering, Temple University, Philadelphia, PA 19122, USA. Electronic address:

This study investigated the regenerability of anion exchange resins for per- and polyfluoroalkyl substances (PFAS), focusing on the interaction between regenerant composition and resin characteristics. The influence of salt type and concentration on PFAS solubility revealed a general decline in perfluorohexane sulfonate (PFHxS) solubility with increased salt concentrations, most strongly with KCl followed by NaCl and NHCl. Mixed solubility results were observed for perfluorooctanoate (PFOA) and perfluorooctane sulfonate (PFOS).

View Article and Find Full Text PDF

Stability of Ternary Drug-Drug-Drug Coamorphous Systems Obtained Through Mechanochemistry.

Pharmaceutics

January 2025

Department of Chemical and Pharmaceutical Sciences, University of Trieste, Piazzale Europa 1, 34127 Trieste, Italy.

This study investigates the preparation of coamorphous systems composed entirely of active pharmaceutical ingredients (APIs), namely praziquantel, niclosamide, and mebendazole. The objective was to formulate and characterize binary and ternary coamorphous systems to evaluate their structural, thermal, and stability properties. Ten different mixtures (binary and ternary) were designed through a mixture design approach and prepared using a sustainable, one-step neat grinding process in a lab-scale vibrational mill.

View Article and Find Full Text PDF

The members of the genus Mill. are notable for producing a diverse range of structurally intricate secondary metabolites, being the focus of current phytochemical research. Their importance is recognized as several species hold significant ethnopharmacological value, being traditionally used to address ailments in human systems, such as respiratory, gastrointestinal, and urinary conditions, among others.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!