Purpose: To investigate the effects of two ultrasonic vibration protocols for cast post removal (single or double ultrasound units) on the development of defects in root dentin.
Methods: Sixty bovine incisors were selected. Fifteen roots were left unprepared (control). Forty-five roots were instrumented and filled. A 10-mm post space was prepared using #1-4 Largo drills. Fifteen teeth were prepared for post space and received no further procedure. Thirty roots had cast posts cemented and were submitted to ultrasonic vibration protocols for removal. The time necessary to remove each post was recorded. Roots were sectioned 3, 6, 9, and 12 mm from the coronal portion and viewed through a 25× magnification in a stereomicroscope. The presence of root fractures, partial cracks, and craze lines was registered. Chi-square and Fisher's exact tests were performed to compare the incidence of dentin defects. The Kruskal-Wallis test was performed to explore the difference between the time needed for post removal. The significance level was set at P = 0.05.
Results: Root defects were observed in all experimental groups. There were no statistical differences comparing previous root canal treatment and post removal steps, either with 1 or 2 ultrasonic units, in the formation of defects (P = 0.544) or fractures (P = 0.679).
Conclusion: Ultrasonic vibration protocols for removing cast posts did not increase the number of dentin defects compared to root canal preparation and obturation and post space preparation steps.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.2334/josnusd.23-0048 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Revolutionizing drug delivery: low-intensity pulsed ultrasound (LIPUS)-driven deep penetration into hypoxic tumor microenvironments of cholangiocarcinoma.
Theranostics
January 2025
College of Pharmacy, Seoul National University, Seoul 08826, South Korea.
Hypoxia is a major obstacle in the treatment of solid tumors because it causes immune escape and therapeutic resistance. Drug penetration into the hypoxic regions of tumor microenvironment (TME) is extremely limited. This study proposes using the unidirectional fluid flow property of low-intensity pulsed ultrasound (LIPUS) to overcome drug penetration limitations in the TME.
View Article and Find Full Text PDFQuantitative evaluation of corrosion-thinning defect by an instantaneous wavenumber multi-shot fusion method based on laser ultrasonic guided wavefield detection.
Ultrasonics
December 2024
Faculty of Information Technology, Beijing University of Technology, Beijing, China.
The thickness loss caused by corrosion is a vital factor that threatens the health of shell structures. It is significant to perform a non-destructive quantitative evaluation of corrosion-thinning defects in plate structures. Based on the laser ultrasonic guided wavefield scanning technology, this paper proposes an instantaneous wavenumber multi-shot fusion method, which improves the performance of the instantaneous wavenumber imaging method.
View Article and Find Full Text PDFApplicability and applications of alternative TOFD techniques.
Ultrasonics
December 2024
NDT&E Laboratory, Dalian University of Technology, Dalian 116085, China. Electronic address:
Ultrasonic time-of-flight diffraction (TOFD) technique is applied to non-destructive testing in engineering, but the dead zone influences its applicable range. Alternative TOFD techniques adopt the indirect diffracted waves having long propagation times to decouple from the lateral wave and detect near-surface defects. It should be noted that the applicability of these diffracted waves varies with parameter conditions employed for detection, e.
View Article and Find Full Text PDFEffect of ultrasound on the physical, biochemical, antioxidant, and antimicrobial properties of industrial Iranian honey.
Arch Razi Inst
June 2024
Department of Food Science and Technology, Science and Research Branch, Islamic Azad University, Tehran, Iran.
The aim of this study was to investigate the effects of ultrasound at two different frequencies, namely 30 kHz and 42 kHz, on various aspects of industrial Iranian honey, including its physical, biochemical, antioxidant and antimicrobial properties. Samples were subjected to ultrasound treatment at 30 kHz or 42 kHz for a duration of 1, 5 or 10 minutes at temperatures of 20 °C or 45 °C, respectively. The following parameters were then evaluated on days 1, 30, 90, and 180: HMF content, pH, acidity, proline concentration, total number of aerobic mesophilic bacteria, diastase activity, moisture content, sucrose concentration, fructose concentration, glucose concentration, fructose- glucose ratio, ABTS (antioxidant activity) content, number of osmophiles, phenol concentration, reducing sugar concentration and total sugar concentration.
View Article and Find Full Text PDFDetecting Selective Laser Melting Beam Power from Ultrasonic Temporal and Spectral Responses of Phononic Crystal Artifacts Toward Real-Time Quality Monitoring.
3D Print Addit Manuf
December 2024
Photo-Acoustics Research Laboratory, Department of Mechanical and Aerospace Engineering, Clarkson University, Potsdam, New York, USA.
Unlike many conventional manufacturing techniques, 3D Printing/Additive Manufacturing (3DP/AM) fabrication creates builds with unprecedented degrees of structural and geometrical complexities. However, uncertainties in 3DP/AM processes and material attributes could cause geometric and structural quality issues in resulting builds and products. Evaluating the sensitivity of process parameters and material properties for process optimization, quality assessment, and closed-loop control is crucial in practice.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!