Renewable resources are being explored to meet the increasing energy demand in the world. The development of RES and their integration into the grid necessitate a voltage conversion to match with the grid voltage. This conversion can be implemented using DC-DC converters. A high-gain DC-DC Converter with low loss is proposed in this article. Thus, the proposed integrated converter is obtained by incorporating a boost converter at the primary side of the flyback converter (FLC) and a VM cell at the secondary side to perform a elevated voltage gain at a lower duty ratio. The Switched Capacitor network is implemented to elevate the voltage gain. The dynamic performance of a controller can be enhanced using an FOPID controller. A comparison analysis has been done using the most recent topologies in order to confirm the superiority of the Proposed converter. A 100W experimental prototype model has been constructed in order to further validate the simulation results. The efficiency of this converter is demonstrably significantly higher than the current topology, according to measured performance. Therefore, it can be said that this topology can be used for applications involving renewable and sustainable energy.
Download full-text PDF |
Source |
|---|---|
| http://www.ncbi.nlm.nih.gov/pmc/articles/PMC10313025 | PMC |
| http://journals.plos.org/plosone/article?id=10.1371/journal.pone.0287770 | PLOS |
Publication Analysis
Top Keywords
Similar Publications
High-voltage pulse generator for time-of-flight mass spectrometry in electrospray thrusters.
Rev Sci Instrum
August 2024
Universidad Carlos III de Madrid, Av. de la Universidad, 30, Leganés, 28911 Madrid, Spain.
Electrospray thrusters exhibit diverse operational modes based on the nature of ejected particles. Time-of-flight mass spectrometry is frequently employed to analyze the composition of the plume. This study introduces a novel converter-based bipolar high-voltage pulse generator aimed at producing synchronized bipolar high-voltage pulses with controllable voltage levels and frequencies, specifically tailored for the study of electrospray thrusters.
View Article and Find Full Text PDFDevelopment and Implementation of LED Street Lights with Bright and Extinguishable Controls and Power Converters.
Micromachines (Basel)
July 2023
Department of Electrical Engineering, Ming Chi University of Technology, New Taipei City 24301, Taiwan.
This study developed and implemented a driving power supply for light-emitting diode (LED) array streetlamps. The power stage was a quasi-resonant (QR)-flyback converter, its input power was the alternating-current power, and the LED array streetlamp was driven by the direct-current output power. The developed QR-flyback converter was operated in discontinuous conduction mode, and the pulse-width modulation (PWM) control chip was used to switch and conduct at the resonant valley of the drain-source voltage on the metal-oxide-semiconductor field-effect transistor (MOSFET) switch to reduce the switching loss.
View Article and Find Full Text PDFDesign and implementation of single switch integrated boost and flyback converter for renewable and sustainable energy.
PLoS One
July 2023
Department of Electrical and Electronics Engineering, SRM Institute of Science and Technology, Kattankulathur, Chennai, India.
Renewable resources are being explored to meet the increasing energy demand in the world. The development of RES and their integration into the grid necessitate a voltage conversion to match with the grid voltage. This conversion can be implemented using DC-DC converters.
View Article and Find Full Text PDFA unipolar compact nanosecond pulsed power supply with high power factor for dielectric barrier discharge applications.
Rev Sci Instrum
August 2022
Electric Engineering, College of Automation, Guangdong University of Technology, Guangzhou, China.
A high voltage with a very short duration and fast rising time is beneficial to generate uniform and diffuse plasma in dielectric barrier discharge (DBD) loads, and a power supply with a high power factor (PF) can reduce the impact on the power grid. According to two requirements, a unipolar high voltage pulsed power supply with power factor correction (PFC) is proposed in this paper. The power supply consists of a unipolar pulse high voltage generating unit, a PFC unit, and a driving circuit.
View Article and Find Full Text PDFLow-Stress and Optimum Design of Boost Converter for Renewable Energy Systems.
Micromachines (Basel)
July 2022
Department of Electrical Engineering, College of Engineering, Taif University, Al-Hawiyah P.O. Box 888, Saudi Arabia.
This paper examines the design and analysis of DC-DC converters for high-power and low-voltage applications such as renewable energy sources (RESs) and comparisons between converters based on switch stresses and efficiency. The RESs including photovoltaic arrays and fuel cell stacks must have enhanced output voltages, such as 380 V DC in the case of a full bridge inverter or 760 V DC in the case of a half bridge inverter, in order to interface with the 220 V AC grid-connected power system. One of the primary difficulties in developing renewable energy systems is enhancing DC-DC converters' efficiency to enable high step-up voltage conversion with high efficiency and low voltage stress.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!