Birds are agile flyers that can maintain flight at high angles of attack (AoA). Such maneuverability is partially enabled by the articulation of wing feathers. Coverts are one of the feather systems that has been observed to deploy simultaneously on both the upper and lower wing sides during flight. This study uses a feather-inspired flap system to investigate the effect of upper and lower side coverts on the aerodynamic forces and moments, as well as examine the interactions between both types of flaps. Results from wind tunnel experiments show that the covert-inspired flaps can modulate lift, drag, and pitching moment. Moreover, simultaneously deflecting covert-inspired flaps on the upper and lower sides of the airfoil exhibit larger force and moment modulation ranges compared to a single-sided flap alone. Data-driven models indicate significant interactions between the upper and lower side flaps, especially during the pre-stall regime for the lift and drag response. The findings from this study are also biologically relevant to the observations of covert feathers deployment during bird flight. Thus, the methods and results summarized here can be used to formulate new hypotheses about the coverts role in bird flight and develop a framework to design covert-inspired flow and flight control devices for engineered vehicles.

Download full-text PDF

Source
http://dx.doi.org/10.1088/1748-3190/acdb1dDOI Listing

Publication Analysis

Top Keywords

upper lower
16
covert-inspired flaps
12
covert feathers
8
lower side
8
lift drag
8
bird flight
8
flight
5
covert-inspired
4
flaps experimental
4
experimental study
4

Similar Publications

Purpose: Motion capture technology is quickly evolving providing researchers, clinicians, and coaches with more access to biomechanics data. Markerless motion capture and inertial measurement units (IMUs) are continually developing biomechanics tools that need validation for dynamic movements before widespread use in applied settings. This study evaluated the validity of a markerless motion capture, IMU, and red, green, blue, and depth (RGBD) camera system as compared to marker-based motion capture during countermovement jumps, overhead squats, lunges, and runs with cuts.

View Article and Find Full Text PDF

Affected by weakening effect of water in the goaf, the bearing capacity of coal pillar reduced, and coal pillar rock burst is prone to occur, which is a serious threat to mine safety in production. In order to study the equivalent width and stability of coal pillar in water-rich coal seam, taking the section coal pillar of a working face as the research object, combined with laboratory test, theoretical analysis, simulation and engineering practice, the stress, elastic core area width, damage degree and energy accumulation of 36 m water-immersed coal pillar and 26 m, 28 m, 30 m, 32 m, 36 m unimmersed coal pillars are analyzed. The research results show that: (1) The reasonable width of coal pillar under flooded and unflooded conditions is 36.

View Article and Find Full Text PDF

Underground coal excavation has caused a series of geological disasters and environmental problems, especially coal mining subsidence. Backfill-strip mining, which combines the advantages of strip mining and backfill mining, can reduce subsidence and improve the recovery rate of coal. Therefore, predicting the impact of backfill-strip mining on the surface environment and strata structure is essential for the better development of backfill-strip mining technology.

View Article and Find Full Text PDF

Traditional sprayers are limited to applying spray mixture solely to the upper surfaces of crops. To overcome this limitation, a variable angle spraying machine (VASM) was designed using a linkage system. This machine enables the adjustment of both the spray position and angle through a single input signal, facilitating multi-directional spraying from the top to the bottom of crops.

View Article and Find Full Text PDF

Introduction: Guided surgery for immediate anterior implants aims to reduce the time required for aesthetic and functional immediate loading. However, the limited surface area of anterior teeth for guide stabilization may affect the accuracy of implant positioning. This in vitro study evaluated the effect of the number of supporting teeth on the accuracy of immediate implants in the maxillary central incisor region.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!