Charge Transfer and Level Lifetime in Molecular Photon-Absorption upon the Quantum Impedance Lorentz Oscillator.

On the strength of the new quantum impedance Lorentz oscillator (QILO) model, a charge-transfer method in molecular photon-absorption is proposed and imaged via the numerical simulations of 1- and 2-photon-absorption (1PA and 2PA) behaviors of the organic compounds LB3 and M4 in this paper. According to the frequencies at the peaks and the full width at half-maximums (FWHMs) of the linear absorptive spectra of the two compounds, we first calculate the effective quantum numbers before and after the electronic transitions. Thus, we obtain the molecular average dipole moments, i.e., 1.8728 × 10 C·m (5.6145 D) for LB3 and 1.9626 × 10 C·m (5.8838 D) for M4 in the ground state in the tetrahydrofuran (THF) solvent. Then, the molecular 2PA cross sections corresponding to wavelength are theoretically inferred and figured out by QILO. As a result, the theoretical cross sections turn out to be in good agreement with the experimental ones. Our results reveal such a charge-transfer image in 1PA near wavelength 425 nm, where an atomic electron of LB3 jumps from the ground-state ellipse orbit with the semimajor axis = 1.2492 × 10 = 1.2492 Å and semiminor axis = 0.4363 Å to the excited-state circle ( = = 2.5399 Å). In addition, during its 2PA process, the same transitional electron in the ground state is excited to the elliptic orbit with = 2.5399 Å and =1.3808 Å, in which the molecular dipole moment reaches as high as 3.4109 × 10 C·m (10.2256 D). In addition, we obtain a level-lifetime formula with the microparticle collision idea of thermal motion, which indicates that the level lifetime is proportional (not inverse) to the damping coefficient or FWHM of an absorptive spectrum. The lifetimes of the two compounds at some excited states are calculated and presented. This formula may be used as an experimental method to verify 1PA and 2PA transition selection rules. The QILO model exhibits the advantage of simplifying the calculation complexity and reducing the high cost associated with the first principle in dealing with quantum properties of optoelectronic materials.