There is an increasing need for an independent terrestrial navigation system, owing to the increasing reliance on global navigation satellite systems (GNSS). The medium-frequency range (MF R-Mode) system is considered a promising alternative; however, the skywave effect caused by ionospheric changes at night can degrade its positioning accuracy. To address this problem, we developed an algorithm to detect and mitigate the skywave effect on MF R-Mode signals. The proposed algorithm was tested using data collected from Continuously Operating Reference Stations (CORS) monitoring the MF R-Mode signals. The skywave detection algorithm is based on the signal-to-noise ratio (SNR) induced by the groundwave and skywave composition, whereas the skywave mitigation algorithm was derived from the I and Q components of the signals obtained through IQ modulation. The results demonstrate a significant improvement in the precision and standard deviation of the range estimation using CW1 and CW2 signals. The standard deviations decreased from 39.01 and 39.28 m to 7.94 and 9.12 m, respectively, while the precision (2-sigma) increased from 92.12 and 79.82 m to 15.62 and 17.84 m, respectively. These findings confirm that the proposed algorithms can enhance the accuracy and reliability of MF R-Mode systems.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC10255736PMC
http://dx.doi.org/10.3390/s23115046DOI Listing

Publication Analysis

Top Keywords

skywave detection
8
continuously operating
8
operating reference
8
r-mode signals
8
skywave
6
r-mode
5
detection mitigation
4
mitigation r-mode
4
r-mode continuously
4
reference station
4

Similar Publications

There is an increasing need for an independent terrestrial navigation system, owing to the increasing reliance on global navigation satellite systems (GNSS). The medium-frequency range (MF R-Mode) system is considered a promising alternative; however, the skywave effect caused by ionospheric changes at night can degrade its positioning accuracy. To address this problem, we developed an algorithm to detect and mitigate the skywave effect on MF R-Mode signals.

View Article and Find Full Text PDF

Loran-C is the most important backup and supplement system for the global navigation satellite system (GNSS). However, existing Loran-C demodulation methods are easily affected by noise and skywave interference (SWI). Therefore, this article proposes a demodulation method based on Loran-C pulse envelope correlation-phase detection (EC-PD), in which EC has two implementation schemes, namely moving average-cross correlation and matched correlation, to reduce the effects of noise and SWI.

View Article and Find Full Text PDF

Ionospheric phase perturbation with large amplitude causes broadening sea clutter's Bragg peaks to overlap each other; the performance of traditional decontamination methods about filtering Bragg peak is poor, which greatly limits the detection performance of HF skywave radars. In view of the ionospheric phase perturbation with large amplitude, this paper proposes a cascaded approach based on improved S-method to correct the ionospheric phase contamination. This approach consists of two correction steps.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!