Reducing the thermal conductivity of thermoelectric materials has been a field of intense research to improve the efficiency of thermoelectric devices. One approach is to create a nanostructured thermoelectric material that has a low thermal conductivity due to its high number of grain boundaries or voids, which scatter phonons. Here, we present a new method based on spark ablation nanoparticle generation to create nanostructured thermoelectric materials, demonstrated using BiTe. The lowest achieved thermal conductivity was <0.1 W m-1 K-1 at room temperature with a mean nanoparticle size of 8±2 nm and a porosity of 44%. This is comparable to the best published nanostructured BiTe films. Oxidation is also shown to be a major issue for nanoporous materials such as the one here, illustrating the importance of immediate, air-tight packaging of such materials after synthesis and deposition.
Download full-text PDF |
Source |
|---|---|
| http://www.ncbi.nlm.nih.gov/pmc/articles/PMC10254237 | PMC |
| http://dx.doi.org/10.3390/nano13111778 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Nanosecond Nanothermometry in an Electron Microscope.
Nano Lett
January 2025
University Paris-Saclay, CNRS, Laboratoire de Physique des Solides, Orsay 91405, France.
Thermal transport in nanostructures plays a critical role in modern technologies. As devices shrink, techniques that can measure thermal properties at nanometer and nanosecond scales are increasingly needed to capture transient, out-of-equilibrium phenomena. We present a novel pump-probe photon-electron method within a scanning transmission electron microscope (STEM) to map temperature dynamics with unprecedented spatial and temporal resolutions.
View Article and Find Full Text PDFLattice defect engineering advances n-type PbSe thermoelectrics.
Nat Commun
January 2025
School of Chemistry and Physics, ARC Research Hub in Zero-emission Power Generation for Carbon Neutrality, and Centre for Materials Science, Queensland University of Technology, Brisbane, QLD, Australia.
Te-free thermoelectrics have garnered significant interest due to their immense thermoelectric potential and low cost. However, most Te-free thermoelectrics have relatively low performance because of the strong electrical and thermal transport conflicts and unsatisfactory compatibility of interfaces between device materials. Here, we develop lattice defect engineering through Cu doping to realize a record-high figure of merit of ~1.
View Article and Find Full Text PDFHigh-Performance Thermoelectric Composite of BiTe Nanosheets and Carbon Aerogel for Harvesting of Environmental Electromagnetic Energy.
ACS Nano
January 2025
State Key Laboratory of Materials Processing and Die & Mould Technology, and School of Materials Science and Engineering, Huazhong University of Science and Technology, Wuhan 430074, Hubei, P. R. China.
Intensifying the severity of electromagnetic (EM) pollution in the environment represents a significant threat to human health and results in considerable energy wastage. Here, we provide a strategy for electricity generation from heat generated by electromagnetic wave radiation captured from the surrounding environment that can reduce the level of electromagnetic pollution while alleviating the energy crisis. We prepared a porous, elastomeric, and lightweight BiTe/carbon aerogel (CN@BiTe) by a simple strategy of induced in situ growth of BiTe nanosheets with three-dimensional (3D) carbon structure, realizing the coupling of electromagnetic wave absorption (EMA) and thermoelectric (TE) properties.
View Article and Find Full Text PDFUnveiling van Hove Singularity-Boosted Photothermoelectric Response for Wearable Human-Radiation Detection.
ACS Sens
December 2024
School of Materials Science and Engineering, Harbin Institute of Technology, Shenzhen 518055, China.
Van Hove singularity (vHs), the singularity point of density of states (DOS) in crystalline solids, is a research hotspot in emerging phenomena such as light-matter interaction, superconducting, and quantum anomalous Hall effect. Although the significance of vHs in photothermoelectric (PTE) effect has been recognized, its integral role in electron excitation and thermoelectric effect is still unclear, particularly in the mid-infrared band that suffers from Pauli blockade in semimetals. Here, we unveil the Fermi-level-modulated PTE behavior in the vicinity of vHs in carbon nanotubes, employing ionic-liquid gating.
View Article and Find Full Text PDFHigh-temperature oxidation kinetics of nanostructured thermoelectric skutterudite CoSb under different environments.
RSC Adv
December 2024
Laboratory for Energetic and Energy Materials Research, Department of Chemistry, National Institute of Technology Calicut Kozhikode 673601 India
Skutterudite CoSb is an n-type thermoelectric material used in thermoelectric generators (TEGs) to recover and convert heat from various sources into electricity. For TEGs, such as CoSb, thermal stability is crucial, especially when exposed to high temperatures and varying environments. To synthesize high-purity nanostructured CoSb, an optimized solvothermal method was developed with detailed investigation of the influence of stoichiometry, solvent choice, and reaction duration on the formation mechanism, as revealed by Powder X-ray diffraction (PXRD).
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!