The widespread distribution of plastic debris in riverine environment is one of the major concerns of environmental pollution because of its potential impact on the aquatic ecosystem. In this study, we investigated the accumulation of metal(loid)s on polystyrene foam (PSF) plastics collected from the floodplain of the Tuul River of Mongolia. The metal(loid)s sorbed on plastics were extracted from the collected PSF via sonication after peroxide oxidation. The size-dependent association of metal(loid)s with plastics indicates that PSFs act as vectors for pollutants in the urban river environment. The mean concentrations of metal(loid)s (i.e., B, Cr, Cu, Na, and Pb) indicate a higher accumulation of the metal(loid)s on meso-sized PSFs compared with macro- and micro-sized PSFs. In addition, the images from scanning electron microscopy (SEM) indicated not only the degraded surface of plastics showing fractures, holes, and pits but also the adhered mineral particles and microorganisms on the PSFs. The interaction of metal(loid)s with plastics was probably facilitated by the physical and chemical properties of altered surface of plastics through photodegradation, followed by an increase in surface area by size reduction and/or biofilm development in the aquatic environment. The enrichment ratio (ER) of metals on PSF samples suggested the continuous accumulation of heavy metals on plastics. Our results demonstrate that the widespread plastic debris could be a carrier of hazardous chemicals in the environment. Considering that the negative impacts of plastic debris on environmental health are major concerns to be addressed, the fate and behavior of the plastics especially their interaction with pollutants in aquatic environments should be further studied.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.ecoenv.2023.115100DOI Listing

Publication Analysis

Top Keywords

plastic debris
12
urban river
8
major concerns
8
accumulation metalloids
8
plastics
8
metalloids plastics
8
surface plastics
8
metalloids
6
plastic-associated metalloids
4
metalloids urban
4

Similar Publications

Microplastic (MP) pollution is an emerging environmental problem worldwide and has caused widespread concern both in terrestrial and aquatic ecosystems due to their potential impacts on the human health, and health of aquatic organisms and the environment. Little is known about the exposure of top marine predators to MP contamination (debris 0.1μm - <5mm, also called MPs).

View Article and Find Full Text PDF

The economic impacts of marine plastic debris in South Africa: A preliminary estimate.

Mar Pollut Bull

December 2024

Council for Scientific and Industrial Research (CSIR), Pretoria, South Africa.

Marine plastic debris can affect the delivery of ecosystem services and cause direct damage to affected industries; with resulting impacts on the economy. This paper applies a version of the benefits transfer method to provide a preliminary estimate of the economic impacts of marine plastic in South Africa, in terms of impacts on ecosystem services, direct damage to industry, and clean-up costs. The total economic impact associated with the plastic reaching South Africa's marine environment each year ranges between R3.

View Article and Find Full Text PDF

Characterization of a biocomposite film using coconut jelly powder to improve arrowroot starch and sodium alginate film forming properties.

Int J Biol Macromol

December 2024

Department of Marine, Faculty of Fisheries and Marine, Universitas Airlangga, Campus C UNAIR, Mulyorejo, Surabaya 60115, Indonesia; Research Group of Post-harvest, Processing Technology, and Bioproducts, Faculty of Fisheries and Marine, Universitas Airlangga, Mulyorejo, Surabaya 60115, Indonesia. Electronic address:

Composite polymers are promising solution to structural setbacks of starch and alginate-based films due to their hydrophilic attributes. Hence, this study aimed to investigate young coconut jelly powder (CJP), an under-utilized by-waste, as a filler using the casting method to develop a novel biocomposite from increments of CJP (1-3 %) to a blended resin of arrowroot starch, sodium alginate, and glycerol. Moreover, the films were characterized by physicomechanical (visual aspect, thickness, color, moisture content, tensile strength, and elongation at break); surface microstructure; water barrier (water vapor permeability, water solubility, and water activities); thermal, crystallinity, and functional group properties; soil, river water, and seawater biodegradability; and coating application in cherry tomato.

View Article and Find Full Text PDF

Polyethylene (PE) is the most-produced polyolefin, and consequently, it is the most widely found plastic waste worldwide. PE biodegradation is under study by applying different (micro)organisms in order to understand the biodegradative mechanism in the majority of microbes. This study aims to identify novel bacterial species with compelling metabolic potential and strategic genetic repertoires for PE biodegradation.

View Article and Find Full Text PDF

Plastic debris in coastal environments usually undergoes weathering due to various environmental conditions. However, the weathering effects on exposed and shaded sides of the same plastics are underexplored. In this study, 1573 plastic fragments were collected from 15 coastal sites worldwide between December 2021 and December 2022, and weathering experiments were conducted outdoors.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!