Printing 3D mesh-like grooves on zinc surface to enhance the stability of aqueous zinc ion batteries.

Aqueous zinc ion batteries (AZIBs) are receiving broad attention owing to their high safety and low cost. However, the high mechanical strength and irreversible growth of zinc dendrites limit the practical application of AZIBs. Herein, regular mesh-like gullies are built on the surface of zinc foil (M150 Zn) by using simple model pressing method and stainless steel mesh as a mold. Due to the charge-enrichment effect, zinc ion deposition and stripping will be preferentially carried out in the grooves to keep the outer surface flat. In addition, zinc is exposed to 002 crystal surface in the gully after being pressed, and the deposited zinc is more inclined to grow at a small angle, so that it has a sedimentary morphology parallel to the basement. Consequently, at a current density of 0.5 mA cm, the M150 zinc anode has a voltage hysteresis of only 35 mV and a cycle life of up to 400 h (relative to a zinc foil of 96 mV and 160 h). Even more imposing is that the full cell has a capacity retention of approximately 100% after 1000 cycles at 2 A g and a specific capacity of almost 60 mAh g when activated carbon is used as the cathode. It is a promising method to improve the stable cycle performance of AZIBs by using a simple method to realize the non-prominent dendrites on the surface of zinc electrode.