Purpose: This study aimed to quantify the extent to which age was associated with joint position sense (JPS) of the asymptomatic shoulder as measured by joint position reproduction (JPR) tasks and assess the reproducibility of these tasks.
Methods: 120 Asymptomatic participants aged 18-70 years each performed 10 JPR-tasks. Both contralateral and ipsilateral JPR-tasks were evaluated on accuracy of JPR under active- and passive conditions at two levels within the shoulder forward flexion trajectory. Each task was performed three times. In a subgroup of 40 participants, the reproducibility of JPR-tasks was assessed one week after initial measurement. Reproducibility of JPR-tasks was evaluated by both reliability (intra-class correlation coefficients (ICC's)) and agreement (standard error of measurement (SEM)) measures.
Results: Age was not associated with increased JPR-errors for any of the contralateral or ipsilateral JPR-tasks. ICC's ranged between 0.63 and 0.80 for contralateral JPR-tasks, and from 0.32 to 0.48 for ipsilateral tasks, except for one ipsilateral task where the reliability was similar to contralateral tasks (0.79). The SEM was comparable and small for all JPR-tasks, ranging between 1.1 and 2.1.
Conclusion: No age-related decline in JPS of the asymptomatic shoulder was found, and good agreement between test and re-test measurements for all JPR-tasks as indicated by the small SEM.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1016/j.jelekin.2023.102792 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Three-Dimensional Assessment of the Condylar Position in Different Malocclusions Using Cone-Beam Computed Tomography: A Cross-Sectional Study.
Cureus
December 2024
Department of Orthodontics, Kothiwal Dental College and Research Centre, Moradabad, IND.
Introduction The role of the condylar position in the correct functioning of the stomatognathic system has been the center of the study. Using cone-beam computed tomography (CBCT), this study looked at the three-dimensional (3D) position of the condylar bone in patients from Class I, Class II, Division 1, and Division 2. Materials and methods This cross-sectional, retrospective study was conducted using 102 CBCT records, with 34 records allocated to each category of malocclusion classification, such as dentoskeletal Class I, skeletal Class II, and dental Class II, Division 1 and 2.
View Article and Find Full Text PDFAssessment of the Accuracy of a Deep Learning Algorithm- and Video-based Motion Capture System in Estimating Snatch Kinematics.
Int J Exerc Sci
December 2024
Department of Sport and Health Sciences, Technical University of Munich, Munich, BY, GERMANY.
In weightlifting, quantitative kinematic analysis is essential for evaluating snatch performance. While marker-based (MB) approaches are commonly used, they are impractical for training or competitions. Markerless video-based (VB) systems utilizing deep learning-based pose estimation algorithms could address this issue.
View Article and Find Full Text PDFNavigated instrumentation and ligament tensioning device enhances initial gap acquisition during total knee arthroplasty procedure: A cadaveric study.
J Exp Orthop
January 2025
Department of Orthopaedic Surgery and Trauma University Center of Montpellier, University of Montpellier Montpellier France.
Purpose: Gap-balanced total knee arthroplasty (TKA) technique relies on initial ligament evaluation, particularly in patient-specific implantation using computer-assisted technologies. This cadaveric study aimed to compare the reproducibility and reliability of medial and lateral gap measurements between manual stress testing and dynamic ligament balancer.
Methods: Initial gap acquisitions were assessed from eight cadaveric knees (four specimens) during the same navigated TKA procedure by five differently skilled surgeons (three seniors and two juniors).
Evaluation of the effects of asymmetric lumbosacral transitional vertebra on pelvic morphology in dogs using ventrodorsal radiographs.
Acta Vet Scand
January 2025
Department of Companion Animal Clinical Sciences, Faculty of Veterinary Medicine, Norwegian University of Life Sciences, Oluf Thesens Vei 30, Ås, Norway.
Background: A lumbosacral transitional vertebra (LTV) is a congenital anomaly of the caudal vertebral column. It has been associated with asymmetrical canine hip dysplasia (CHD) and cauda equina syndrome (CES) in German Shepherd dogs. This retrospective cross-sectional study aims to report the potential influence of asymmetric LTV on pelvic anatomy using ventrodorsal (VD) radiographs.
View Article and Find Full Text PDFBending behavior and influence parameter optimization of connection joints of disc-buckle type formwork support.
Sci Rep
January 2025
China Construction Fifth Engineering Division Corp., Ltd., Changsha, 410004, China.
In order to systematically study the bending behavior of the connection joints of the disc-buckle type formwork support, the accurate numerical model of the disc-buckle type connection joints was obtained through the experimental on the bending behavior of the connection joints of the disc-buckle type, and the bending moment-rotation curve of the joints was verified. The analysis of the failure mode and stress distribution of the joints reveals the importance of the bending behavior of each component. By establishing an accurate numerical model of the joint, the accuracy of the bending experiment of the joint was verified, and the parametric analysis of the influence factors such as the depth of the wedge insertion the disk-plate, the initial position of the wedge insertion the disk-plate, the thickness of the wedge, material constitutive of the wedge and the thickness of the disk-plate was carried out to grasp the influence of the relevant parameters on the bending behavior of the joint.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!