Characterization of high intensity progressive ultrasound beams in air at 300 kHz.

The majority of reported measurements on high intensity ultrasound beams in air are below 40 kHz and performed on standing waves inside of a guide. Here, experimental characterization of high intensity progressive and divergent sound beams in air at 300 kHz are presented. Measurements in this frequency range are challenging. Accurate characterization of high intensity sound beams requires a measurement bandwidth at least ten times the beam's primary frequency, as high intensity soundwaves steepen and form shocks and, therefore, contain significant signal power at harmonic frequencies. Hence, a measurement bandwidth of at least 3 MHz is required. Calibrated measurement microphones are generally not available in this frequency range. This limitation has been overcome by using a hydrophone with a calibrated response from 250 kHz to 20 MHz. A narrowband piezoelectric transducer is used as the source in this study, and it is capable of generating tone burst waveforms centered at 300 kHz with 160 dB sound pressure level surface pressure. Cumulative wave steepening and shock formation are observed in on-axis measurements. The source's surface vibration profile is measured using a scanning laser Doppler vibrometer, and the vibration profile is imported into a numerical wide-angle Khokhlov-Zabolotskaya-Kuznetsov simulation for comparison against measured on-axis waveforms.