Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1097/ALN.0000000000004565 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
On-Demand Selection of the Latent Domain Orientation in Spray-Deposited Block Copolymer Thin Films.
ACS Nano
January 2025
Center for Functional Nanomaterials, Brookhaven National Laboratory, Upton, New York 11973, United States.
With their ability to self-assemble spontaneously into well-defined nanoscale morphologies, block copolymer (BCP) thin films are a versatile platform to fabricate functional nanomaterials. An important challenge to wider deployment of BCPs in nanofabrication is combining precise control over the nanoscale domain orientation in BCP assemblies with scalable deposition techniques that are applicable to large-area, curved, and flexible substrates. Here, we show that spray-deposited smooth films of a nominally disordered BCP exhibit latent orientations, which can be prescriptively selected by controlling solvent evaporation during spray casting.
View Article and Find Full Text PDFCasting a wider net for tuberculosis cases.
Eur Respir J
January 2025
University of South Florida, College of Public Health and Morsani College of Medicine, Tampa, FL, USA
Analysis of Static and Cyclic Properties of 316L and AlSi10Mg in Conventional Casting and Additive Manufacturing.
Materials (Basel)
November 2024
Institude of Applied Mechanics and Mechatronics, Slovak University of Technology, Námestie Slobody 17, 81231 Bratislava, Slovakia.
The paper presents the original results of cyclic testing of materials that are identical in chemical composition but produced by two different technologies: conventional metallurgy and additive manufacturing. For the aluminium alloy AlSi10Mg and the austenitic steel 316L, tensile curves, tension-compression and torsion alternating fatigue curves are experimentally obtained and presented. The experimental results are compared for two fabrication technologies-conventional metallurgy and additive DLMS technology.
View Article and Find Full Text PDFTransverse dentoalveolar development in Chinese children and adolescents: A cross-sectional study using revised Andrews' Element III analysis.
Am J Orthod Dentofacial Orthop
October 2024
State Key Laboratory of Oral Diseases & National Center for Stomatology & National Clinical Research Center for Oral Diseases, West China Hospital of Stomatology, Sichuan University, Chengdu, Sichuan, China. Electronic address:
Introduction: This study investigated the prevalence of maxillary transverse deficiency (MTD) in Chinese children and adolescents using revised Andrews' Element III analysis and studied transverse developmental characteristics of the maxillomandibular complex.
Methods: Plaster or digital casts of 794 participants aged 7-18 years were evaluated. MTD was diagnosed when the maxilla-mandible width difference, represented by the decompensated maxillary and mandibular first molars, exceeded 4 mm.
Liquid state properties and amorphous solidification kinetics of multicomponent Fe_{50-x}Co_{x}Cr_{14}Mo_{14}C_{9}B_{8}Tm_{5} alloys investigated under containerless processing conditions.
Phys Rev E
September 2024
School of Physical Science and Technology, Northwestern Polytechnical University, Xi'an 710072, China.
The liquid state thermophysical properties and amorphous solidification kinetics of Fe_{50-x}Co_{x}Cr_{14}Mo_{14}C_{9}B_{8}Tm_{5} (x=10, 15, 20, and 25) alloys were explored by electromagnetic and electrostatic levitation techniques. It was found that the surface tension of liquid alloys with Fe contents below 30 at. % had a strong temperature dependence.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!