Petroleum and Chemical Engineering, Faculty of Engineering, Universiti Teknologi Brunei, Bandar Seri Begawan, BE1410, Brunei Darussalam.
Published: May 2023
AI Article Synopsis
Article Abstract
A limited experimental work was on multi-walled carbon nanotube (MWCNT)-water nanofluid with surfactant in the solar parabolic collector at low volume concentrations. At high-volume concentrated nanofluid, the pressure drop was more due to an increase in the viscosity of the working fluid and an increase in the nanoparticle cost; hence it is not economical. This report attempted to use Sodium Dodecyl Benzene Sulfonate (SDBS) surfactant in the low-volume concentrated MWCNT-water nanofluid to establish effective heat transfer in solar parabolic collector applications. The stable MWCNT-water nanofluid was prepared at 0.0158, 0.0238, and 0.0317 volume concentrations. The experiments were conducted from 10:00 to 16:00 at 6, 6.5 and 7 L/min flow rates concerning ASHRAE Standards. At the 7 L/min flow rate of the working fluid, having a minimum temperature difference between the working fluid and absorber tube leads to better heat transfer. The increased volume concentration of MWCNT in the water enhances the surface area interaction between water and MWCNT nanoparticles. This results in maximum solar parabolic collector efficiency at 0.0317 vol% with a 7 L/min flow rate and 10-11% higher than the distilled water.
In this study, we investigated the influence of structural parameters, including active region dimensions, electric field intensity, In-composition, impurity position, and potential profiles, on the energy levels, sub-gap transitions, and photovoltaic characteristics of a p-GaN/i-(In, Ga)N/GaN-n (p-QW-n) structure. The finite element method (FEM) has been used to solve numerically the Schrödinger equation. We found that particle and sub-gap energy levels are susceptible to well width, electric field, and impurity position.
In this study, a sustainable method employing concentrated sunlight to achieve environmental remediation of wastewater, contaminated by Ciprofloxacin antibiotic (CIP), is thoroughly investigated. A green ZnO/g-CN nanocomposite (NC) is used as a photocatalyst coating on glass to investigate the inactivation of CIP in water, in a flow-reactor configuration at small-prototype scale (10 liters/h, catalyst area 187.5 cm).
This study presents a theoretical investigation into the photovoltaic efficiency of InGaN/GaN quantum well-based intermediate band solar cells (IBSCs) under the simultaneous influence of electric and magnetic fields. The finite element method is employed to numerically solve the one-dimensional Schrödinger equation within the framework of the effective-mass approximation. Our findings reveal that electric and magnetic fields significantly influence the energy levels of electrons and holes, optical transition energies, open-circuit voltages, short-circuit currents, and overall photovoltaic conversion performances of IBSCs.
Fermented cassava roasting, used for producing the popular Nigerian food gari, traditionally relies on firewood, which is inefficient and poses health risks to rural communities, particularly for women and children.
This study explores a solar-powered roasting system using a concentrated parabolic solar collector, achieving higher and more efficient roasting temperatures (118°C - 154°C) compared to traditional methods.
The system not only reduces harmful smoke emissions but also supports sustainable practices, aiming to alleviate health risks and contribute to zero-emission goals in gari production.
In past years, concentrated solar power (CSP) with an energy backup system has been a unique renewable energy utilization system among intermittent renewable energy systems. It could allow a CSP plant to operate as a base load system in the future. This paper simulates a solar power plant for 1 MWe.
