Estimating and minimizing movement artifacts in surface electromyogram.

While recording surface electromyography [sEMG], it is possible to record the electrical activities coming from the muscles and transients in the half-cell potential at the electrode-electrolyte interface due to micromovements of the electrode-skin interface. Separating the two sources of electrical activity usually fails due to the overlapping frequency characteristics of the signals. This paper aims to develop a method that detects movement artifacts and suggests a minimization technique. Towards that aim, we first estimated the frequency characteristics of movement artifacts under various static and dynamic experimental conditions. We found that the extent of the movement artifact depended on the nature of the movement and varied from person to person. Our study's highest movement artifact frequency for the stand position was 10 Hz, tiptoe 22, walk 32, run 23, jump from box 41, and jump up and down 40 Hz. Secondly, using a 40 Hz highpass filter, we cut out most of the frequencies belonging to the movement artifacts. Finally, we checked whether the latencies and amplitudes of reflex and direct muscle responses were still observed in the highpass-filtered sEMG. We showed that the 40 Hz highpass filter did not significantly alter reflex and direct muscle variables. Therefore, we recommend that researchers who use sEMG under similar conditions employ the recommended level of highpass filtering to reduce movement artifacts from their records. However, suppose different movement conditions are used. In that case, it is best to estimate the frequency characteristics of the movement artifact before applying any highpass filtering to minimize movement artifacts and their harmonics from sEMG.