Introduction: Electronic nicotine delivery system (ENDS) device and liquid characteristics (e.g., wattage, nicotine concentration) are diverse and important in determining product appeal, aerosol volume/nicotine levels, and toxicity. Little is known about how device and liquid characteristics vary by flavor; we address this gap to identify potential regulatory implications.
Methods: Data are from a longitudinal cohort study (Waves 2 and 3; December 2020-December 2021) of adult (≥21 years) U.S. ENDS users (≥5 days of use/week). Participants (n = 1809) reported on and submitted photos of their most used device and liquid. Participants were categorized into flavor groups of high prevalence in our sample and in prior literature: sweet, menthol/mint, or tobacco. Participants using liquids without nicotine or flavors other than sweet, menthol/mint, or tobacco were excluded (n = 320). Data were analyzed cross-sectionally. Chi-square and linear regression (n = 1489) were used to examine device and liquid characteristics by flavor.
Results: Sweet flavors were most common (n = 1135; 76.2%), followed by menthol/mint (n = 214, 14.4%) and tobacco (n = 140, 9.4%). Sweet flavors were less common among participants using reusable devices with disposable pods/cartridges (nicotine salt) than those using other device-liquid groupings (5.2% vs 86.5-93.9%; p < 0.001). Sweet flavors were less common among those using ENDS for non-flavor reasons vs the flavor (73.5% vs 90.4%; p < 0.001). Sweet flavors correlated with lower nicotine concentrations, higher wattages, and lower ages of ENDS first use (p < 0.001).
Conclusions: Regulatory agencies must consider how regulations on device and liquid characteristics may affect ENDS users' behaviors (e.g., limiting availability of sweet flavors may encourage use of non-sweet flavors and lower wattages).
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC10330428 | PMC |
http://dx.doi.org/10.1016/j.addbeh.2023.107727 | DOI Listing |
Nanomaterials (Basel)
January 2025
School of Artificial Intelligence, Optics and Electronics (iOPEN), Northwestern Polytechnical University, Xi'an 710072, China.
This study presents a novel reflective fiber Fabry-Perot (F-P) salinity sensor. The sensor employs a femtosecond laser to fabricate an open liquid cavity, facilitating the unobstructed ingress and egress of the liquid, thereby enabling the direct involvement of the liquid in light transmission. Variations in the refractive index of the liquid induce corresponding changes in the effective refractive index of the optical path, which subsequently influences the output spectrum.
View Article and Find Full Text PDFNano Lett
January 2025
School of Chemical Engineering, Zhengzhou University, Zhengzhou 450001, China.
Lubrication surfaces reduce the risk of cross-contamination and enhance the long-term stability of medical devices, which holds significance in the realm of antifouling medical materials. However, the complexity of constructing micronano structures to immobilize lubricating fluids and the fluorine content typically found in silane coupling agents restrict their widespread adoption. In this study, we prepared a biomimetic lubricating coating (BLC) through the one-step self-assembly of octadecyltrichlorosilane and oil infusion.
View Article and Find Full Text PDFBiomed Chromatogr
February 2025
Department of Chemistry, GITAM School of Science, GITAM Deemed to Be University, Hyderabad, India.
A simple LC method has been developed and validated for estimating budesonide (epimer B + A) and formoterol fumarate dihydrate in dry powder inhalation. The development results of this study make it very significant. The degradation and process impurities in EP and ChP were identified in addition to budesonide and formoterol fumarate.
View Article and Find Full Text PDFJ Transl Med
January 2025
State Key Laboratory of Digital Medical Engineering, School of Biological Science and Medical Engineering, Southeast University, 211189, Nanjing, China.
Nat Comput Sci
January 2025
Key Lab of Fabrication Technologies for Integrated Circuits and Key Laboratory of Microelectronic Devices and Integrated Technology, Institute of Microelectronics of the Chinese Academy of Sciences, Beijing, China.
The human brain is a complex spiking neural network (SNN) capable of learning multimodal signals in a zero-shot manner by generalizing existing knowledge. Remarkably, it maintains minimal power consumption through event-based signal propagation. However, replicating the human brain in neuromorphic hardware presents both hardware and software challenges.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!