Interatomic potentials for the BΣ states of CsAr, CsXe, and RbXe have been determined through comparisons of experimental B ← X absorption spectra for alkali vapor-rare gas mixtures with calculations of the Franck-Condon factors (FCFs) associated with free-free transitions of thermal atomic pairs. Simulations of optical transitions of alkali-rare gas atomic pairs between the thermal and vibrational continua of the XΣ and BΣ states of the molecule, responsible for the blue satellites of the Cs and Rb D resonance lines in a rare gas background, require the incorporation of ground-state values above ∼400 into the FCF calculations and proper normalization of the free-particle wave functions. Absorption spectra computed on the basis of several X and B state interatomic potentials available in the literature were found to be sensitive to the height of the BΣ state barrier, as well as the XΣ state repulsive wall contour and the location of the van der Waals minimum. Other spectral simulations entailed iterative modifications to a selected BΣ interatomic potential, again coupled with comparison to experimental B ← X spectra. Comparisons of calculated spectra with experiment yield a CsXe BΣ potential, for example, exhibiting a barrier height of 76 cm at 5.2 Å and yet is nearly flat at smaller values of internuclear separation (). The latter contrasts with previous theoretical calculations of () in the vicinity of the barrier maximum. For the CsAr molecule, the BΣ barrier height was found to be 221 cm, which is within 3% of the value determined from pseudopotential calculations incorporating the spin-orbit effect. Reproducing Cs-rare gas experimental absorption spectra also requires the existence of a broad, shallow potential well lying beyond the BΣ barrier that, for CsAr, has a dissociation energy ( ∼ 24 cm) a factor of 3 larger than values predicted by theory. Similar results are obtained for the RbXe and CsXe complexes.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC10150394PMC
http://dx.doi.org/10.1021/acs.jpca.2c07274DOI Listing

Publication Analysis

Top Keywords

absorption spectra
16
interatomic potentials
12
csar csxe
8
csxe rbxe
8
8
bΣ interatomic
8
calculations franck-condon
8
franck-condon factors
8
optical transitions
8
bΣ states
8

Similar Publications

The surface termination of a Fe (III) spin crossover molecular salt.

J Phys Condens Matter

January 2025

Department of Physics and Astronomy, University of Nebraska, 855 North 16th Street, Lincoln , 68588-0299, UNITED STATES.

From a comparison of the known molecular stoichiometry and X-ray photoemission spectroscopy (XPS), it is evident that the Fe(III) spin crossover salt [Fe(qsal)2Ni(dmit)2], where qsal = N(8quinolyl)salicylaldimine, and dmit2- = 1,3-dithiol-2-thione-4,5-dithiolato has a preferential surface termination with the Ni(dmit)2 moiety. This preferential surface termination leads to a significant surface to bulk core level shift for the Ni 2p X-ray photoemission core level, not seen in the corresponding Fe 2p core level spectra. A similar surface to bulk core level shift is seen in Pd 3d in the related [Fe(qsal)2]2Pd(dmit)2, ], where qsal = N(8quinolyl)salicylaldimine, and dmit2- = 1,3-dithiol-2-thione-4,5-dithiolato.

View Article and Find Full Text PDF

For noninvasive light-based physiological monitoring, optimal wavelengths of individual tissue components can be identified using absorption spectroscopy. However, because of the lack of sensitivity of hardware at longer wavelengths, absorption spectroscopy has typically been applied for wavelengths in the visible (VIS) and near-infrared (NIR) range from 400 to 1,000 nm. Hardware advancements in the short-wave infrared (SWIR) range have enabled investigators to explore wavelengths in the ~1,000 nm to 3,000 nm range in which fall characteristic absorption peaks for lipid, protein, and water.

View Article and Find Full Text PDF

Time-resolved spectroscopy is an important tool for probing photochemically induced nonequilibrium dynamics and energy transfer. Herein, a method is developed for the ab initio simulation of vibronic spectra and dynamical processes. This framework utilizes the recently developed nuclear-electronic orbital time-dependent configuration interaction (NEO-TDCI) approach, which treats all electrons and specified nuclei quantum mechanically on the same footing.

View Article and Find Full Text PDF

This study explores the optoelectronic and photovoltaic potential of acceptor-π-donor (A-π-D) architectures utilizing CSi quantum dots (CSiQDs) through a combination of density functional theory (DFT) and time-dependent DFT (TDDFT). We examined two key structural configurations: C-C and Si-C conformers. In these systems, CSiQDs serve as the acceptor, CHSF as the π-bridge, and 3 × (CHO) as the donor.

View Article and Find Full Text PDF

Optical Properties of Phenylthiolate-Capped CdS Nanoparticles.

J Phys Chem C Nanomater Interfaces

January 2025

Department of Chemistry, University College London, 20 Gordon Street, London WC1H 0AJ, U.K.

Using many-body perturbation theory, we study the optical properties of phenylthiolate-capped cadmium sulfide nanoparticles to understand the origin of the experimentally observed blue shift in those properties with decreasing particle size. We show that the absorption spectra predicted by many-body perturbation theory agree well with the experimentally measured spectra. The results of our calculations demonstrate that all low-energy excited states correspond to a mixture of two fundamental types of excitations: intraligand and ligand-to-metal charge-transfer excitations.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!