Convolutional Neural Networks (CNN) have shown promising results for displacement estimation in UltraSound Elastography (USE). Many modifications have been proposed to improve the displacement estimation of CNNs for USE in the axial direction. However, the lateral strain, which is essential in several downstream tasks such as the inverse problem of elasticity imaging, remains a challenge. The lateral strain estimation is complicated since the motion and the sampling frequency in this direction are substantially lower than the axial one, and a lack of carrier signal in this direction. In computer vision applications, the axial and the lateral motions are independent. In contrast, the tissue motion pattern in USE is governed by laws of physics which link the axial and lateral displacements. In this paper, inspired by Hooke's law, we, first propose Physically Inspired ConsTraint for Unsupervised Regularized Elastography (PICTURE), where we impose a constraint on the Effective Poisson's ratio (EPR) to improve the lateral strain estimation. In the next step, we propose self-supervised PICTURE (sPICTURE) to further enhance the strain image estimation. Extensive experiments on simulation, experimental phantom and in vivo data demonstrate that the proposed methods estimate accurate axial and lateral strain maps.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1109/TMI.2022.3230635 | DOI Listing |
Am J Phys Med Rehabil
January 2025
Department of Physical Therapy, Akita University Graduate School of Health Sciences, 1-1-1 Hondo, Akita 010-8543, Japan.
Objective: To investigate whether the impacts of height increase on gastrocnemius muscle (GM) stiffness are greater in children with spastic cerebral palsy (CP) than in those with typical development (TD).
Design: This one-year cohort study enrolled children (CP, 23; TD, 23) who underwent two measurements conducted at entry and after one year. Lateral and medial GM-strain ratios representing muscle stiffness were obtained using elastography.
ACS Appl Mater Interfaces
January 2025
Ningbo Institute of Materials Technology and Engineering, Chinese Academy of Sciences, Ningbo 315201, China.
The controllable synthesis of epitaxial nanopillar arrays is fundamentally important to the development of advanced electrical and optical devices. However, this fascinating growth method has rarely been applied to the bottom-up synthesis of plasmonic nanostructure arrays (PNAs) with many broad, important, and promising applications in optical sensing, nonlinear optics, surface-enhanced spectroscopies, photothermal conversion, photochemistry, etc. Here, a one-step epitaxial approach to single-crystalline NbTiN (NbTiN) nanopillar arrays based on the layer plus island growth mode is demonstrated by strain engineering.
View Article and Find Full Text PDFLight Sci Appl
January 2025
Department of Mechanical Engineering, The University of Hong Kong, Hong Kong, China.
Oxide materials with a non-centrosymmetric structure exhibit bulk photovoltaic effect (BPVE) but with a low cell efficiency. Over the past few years, relatively larger BPVE coefficients have been reported for two-dimensional (2D) layers and stacks with asymmety-induced spontaneous polarization. Here, we report a crucial breakthrough in boosting the BPVE in 3R-MoS by adopting edge contact (EC) geometry using bismuth semimetal electrode.
View Article and Find Full Text PDFPoult Sci
December 2024
Department of Poultry Science, University of Arkansas, Fayetteville, Arkansas, USA 72701. Electronic address:
Fast growth rate and stocking density are global animal welfare concerns for broiler chickens. The objective of this study was to evaluate the effect of genetic strain and stocking density on the behavior of broilers. In a 2 × 2 randomized complete block design, conventional (CONV) and slow-growing (SG) broilers were stocked at either 29 kg/m (LO, n = 31 birds/pen) or 37 kg/m (HI, n = 40 birds/pen) in 16 pens (n = 4 pens/treatment).
View Article and Find Full Text PDFAnn Biomed Eng
December 2024
Department of Mechanical Engineering and Materials Science, Washington University in St. Louis, 1 Brookings Drive, MSC 1185-208-125, St. Louis, MO, 63130, USA.
Purpose: To determine how the biomechanical vulnerability of the human brain is affected by features of individual anatomy and loading.
Methods: To identify the features that contribute most to brain vulnerability, we imparted mild harmonic acceleration to the head and measured the resulting brain motion and deformation using magnetic resonance elastography (MRE). Oscillatory motion was imparted to the heads of adult participants using a lateral actuator (n = 24) or occipital actuator (n = 24) at 20 Hz, 30 Hz, and 50 Hz.
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!