A free-standing polyamide (PA) film is fabricated via in situ release from a thin-film composite (TFC) membrane achieved through the removal of the polysulfone support. The structure parameter of the PA film is measured to be 24.2 ± 12.6 μm, which is about 87-fold of its film thickness. A significant decline in water flux of the PA film from an ideal forward osmosis membrane is observed. We find that the decline is predominantly influenced by the internal concentration polarization (ICP) of the PA film based on our experimental measurements and theoretical calculations. We propose that the asymmetric hollow structures of the PA layer with dense crusts and cavities may be the underlying cause of the occurrence of the ICP. More importantly, the structure parameter of the PA film can be reduced and its ICP effect can be mitigated by tuning its structures with fewer and shorter cavities. Our results for the first time provide experimental evidence to prove that the PA layer of the TFC membrane has the ICP effect, which could potentially provide fundamental insights into the influence of structural properties of PA on the membrane separation performance.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1021/acs.est.2c09009 | DOI Listing |
Eur J Intern Med
January 2025
Cardiology Department, Hospital Clínico Universitario, Universitat de València, INCLIVA, Valencia, Spain; CIBER Cardiovascular, Madrid, Spain.
Aims: Hypoalbuminemia is frequently found in patients with heart failure (HF), associated with higher morbimortality in acute HF (AHF). Moreover, Carbohydrate Antigen 125 (CA125) is elevated in most of the AHF patients. In this cohort of patients admitted for AHF, our objective was to evaluate the association between hypoalbuminemia and long-term outcomes, including mortality and HF readmissions, stratified by CA125 concentration.
View Article and Find Full Text PDFJ Am Chem Soc
January 2025
College of Engineering and Applied Sciences, Jiangsu Key Laboratory of Artificial Functional Materials, National Laboratory of Solid State Microstructures, Collaborative Innovation Centre of Advanced Microstructures, Nanjing University, Nanjing 210093, P. R. China.
The rapid advancements in 3C electronic devices necessitate an increase in the charge cutoff voltage of LiCoO to unlock a higher energy density that surpasses the currently available levels. However, the structural devastation and electrochemical decay of LiCoO are significantly exacerbated, particularly at ≥4.5 V, due to the stress concentration caused by more severe lattice expansion and shrinkage, coupled with heterogeneous Li intercalation/deintercalation reactions.
View Article and Find Full Text PDFEnviron Sci Technol
January 2025
Key Laboratory for Semi-Arid Climate Change of the Ministry of Education, College of Atmospheric Sciences, Lanzhou University, Lanzhou 730000, China.
The record-breaking 2019-2020 Australian wildfires have been primarily linked to climate change and its internal variability. However, the meteorological feedback mechanisms affecting smoke dispersion and wildfire emissions on a synoptic scale remain unclear. This study focused on the largest wildfires occurring between December 25, 2019 and January 10, 2020, under the enhanced subtropical high, when the double peak in wildfire evolution was favored by sustained low humidity and two synchronous increases in temperature and wind.
View Article and Find Full Text PDFEur J Clin Microbiol Infect Dis
January 2025
Department of Medical Microbiology, PGIMER, Chandigarh, Chandigarh, 160012, India.
Cefepime-tazobactam (FEP-TAZ) consists of cefepime combined with tazobactam, a penicillanic acid-sulfone recognized as an established beta-lactamase inhibitor. This study aims to investigate the in-vitro effectiveness of FEP-TAZ against cefepime-resistant clinical isolates of Escherichia coli (E. coli).
View Article and Find Full Text PDFMater Horiz
January 2025
Department of Materials Science and Engineering, Pohang University of Science and Technology (POSTECH), Pohang 37673, Republic of Korea.
Currently, it is a significant challenge to achieve long-term cyclability and fast chargeability in lithium-ion batteries, especially for the Ni-based oxide cathode, due to severe chemo-mechanical degradation. Despite its importance, the fast charging long-term cycling behaviour is not well understood. Therefore, we comprehensively evaluate the feasibility of fast charging applications for Co-free layered oxide cathodes, with a focus on the extractable capacity and cyclability.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!