Metal-directed interfacial self-assembly of well-defined coordination polymer (CP) ultrathin films can control the metal complex arrangement and distribution at the molecular level, providing a convenient route for the design and fabrication of novel opto-electrical devices and heterogeneous catalysts. Here, we report the assembly of two series of CP multilayers with the transition-metal ions of Fe, Co, Zn and Tb as connectors and tripodal terpyridyl ligands of 4,4',4″-(1,3,5-triazine-2,4,6-triyl)tris(1-(4-([2,2':6',2″-terpyridin]-4'-yl)benzyl)pyridin-1-ium) (TerPyTa) and 4,4',4″-(benzene-1,3,5-triyl)tris(1-(4-([2,2':6',2″-terpyridin]-4'-yl)benzyl)pyridin-1-ium) (TerPyBen) as linkers at the air-water interface. The as-prepared Langmuir-Blodgett (LB) films display strong luminescence, with the emission wavelength and relative intensity dependent on both the metal ions and linkers; among them, the Zn-TerPyTa and Zn-TerPyBen CPs give off the strongest luminescent emission centered at about 370 nm with an emission lifetime of approximately 0.2-0.3 ns. The Tb-TerPyTa CPs can give off emission at approximately 490, 546, 586, and 622 nm, attributed to the D to F electron transitions of typical Tb ions. Finally, these CP LB films can act as efficient heterogeneous photocatalysts for the CO reduction to selectively produce CO. The catalytic efficiency can be optimized by adjusting the experimental conditions (light sensitizer, electron donor, and water content) and CP composition (metal ion and ligand) with an excellent yield of up to 248.1 mmol g. In particular, it is revealed that, under the same conditions, the catalytic efficiency of the Fe-TerPyTa CP LB film is nearly 2 to 3 orders of magnitude higher than that of the other metalated complexes investigated in the homogeneous system. UV-vis spectroscopy and cyclic voltammetry studies demonstrated that the dual active sites of Fe-terpyridine and TerPyTa units contribute to the enhanced catalytic activity. This work provides an effective method to introduce the earth-abundant metal complexes into CP films to construct efficient noble-metal-free photocatalysts for the CO reduction.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1021/acs.langmuir.3c00166 | DOI Listing |
J Am Chem Soc
January 2025
Engineering Research Center of Advanced Rare Earth Materials (Ministry of Education), Department of Chemistry, Tsinghua University, Beijing 100084, China.
Hierarchical structures are essential in natural adhesion systems. Replicating these in synthetic adhesives is challenging due to intricate molecular mechanisms and multiscale processes. Here, we report three phosphorylated peptides featuring a hydrophobic self-assembly motif linked to a hydrophilic phosphorylated sequence (pSGSS), forming peptide fibril nanoframeworks.
View Article and Find Full Text PDFAngew Chem Int Ed Engl
January 2025
Key Laboratory for Advanced Materials and Joint International Research Laboratory of Precision Chemistry and Molecular Engineering, Shanghai Key Laboratory of Functional Materials Chemistry, Feringa Nobel Prize Scientist Joint Research Center, Frontiers Science Center for Materiobiology and Dynamic Chemistry, Institute of Fine Chemicals, School of Chemistry and Molecular Engineering, East China University of Science and Technology, Shanghai, China.
Currently, the development of polymeric hole-transporting materials (HTMs) lags behind that of small-molecule HTMs in inverted perovskite solar cells (PSCs). A critical challenge is that conventional polymeric HTMs are incapable of forming ultra-thin and conformal coatings like self-assembly monolayers (SAMs), especially for substrates with rough surface morphology. Herein, we address this challenge by designing anchorable polymeric HTMs (CP1 to CP5).
View Article and Find Full Text PDFACS Nano
January 2025
School of Chemistry and Chemical Engineering, National Special Superfine Powder Engineering Research Center, Nanjing University of Science and Technology, Nanjing 210094, China.
Constructing a strong bonded interface is highly desired to build fast charge-transfer channels and tune reactive sites for optimizing CO photoreduction. In this work, a covalent triazine framework (CTF) combined with a BiSBr heterojunction is designed using an electrostatic self-assembly process. Due to the oppositely charged states between two components and ultrasonic treatment, a strong coupled interface is realized with the formation of Bi-C/N/O bonds, leading to robust interfacial polarization.
View Article and Find Full Text PDFACS Appl Mater Interfaces
January 2025
3B's Research Group, I3Bs─Research Institute on Biomaterials, Biodegradables and Biomimetics, University of Minho, Headquarters of the European Institute of Excellence on Tissue Engineering and Regenerative Medicine, AvePark, Parque de Ciência e Tecnologia, Zona Industrial da Gandra, 4805-694 Barco, Guimarães, Portugal.
Nervous system disorders are characterized by a progressive loss of function and structure of neurons that ultimately leads to a decline in cognitive and motor functions. In this study, we used interfacial polyelectrolyte complexation (IPC) to produce fibers for neural tissue regeneration. IPC is a processing method that allows spinning of sensitive biopolymers.
View Article and Find Full Text PDFACS Nano
January 2025
Department of Chemistry, University of Minnesota, Minneapolis, Minnesota 55455, United States.
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!