Microliter spotting and micro-colony observation: A rapid and simple approach for counting bacterial colony forming units.

For enumerating viable bacteria, traditional dilution plating to count colony forming units (CFUs) has always been the preferred method in microbiology owing to its simplicity, albeit being laborious and time-consuming. Similar CFU counts can be obtained by quantifying growing micro-colonies in conjunction with the benefits of a microscope. Here, we employed a simple method of five to ten microliter spotting of a diluted bacterial culture multiple times on a single Petri dish followed by determining CFU by counting micro-colonies using a phase-contrast microscope. In this method, the CFU of an Escherichia coli culture can be estimated within a four-hour period after spotting. Further, within a ten-hour period after spotting, CFU in a culture of Ralstonia solanacearum, a bacterium with a generation time of around 2 h, can be estimated. The CFU number determined by micro-colonies observed for 10-fold dilutions or lower is similar to that obtained by the dilution plating method for 10-fold dilutions or lower. Micro-colony numbers observed in the early hours of growth (2 h in case of E. coli and 8 h in case of R. solanacearum) were found to remain consistent at later hours (4 h in case of E. coli and 10 h in case of R. solanacearum), where the visibility of the colonies was better due to a noticeable increase in the size of the colonies. This suggested that micro-colonies observed in the early hours indeed represent the bacterial number in the culture. Practical applications to this counting method were employed in studying the rifampicin-resistant mutation rate as well as performing a fluctuation test in E. coli. The spotting method described here to enumerate bacterial CFU results in reduction of labour, time and resources.