Contamination of industry-derived antimony (Sb) is currently of great concern. This study was conducted to identify the source of Sb together with other potential toxic elements (PTEs) in a typical industrial area in China and emphasize the contribution of Sb to ecological risk in the local aquatic environment. By investigating the distribution of nine PTEs in surface water in Wujiang County in dry and wet seasons, this study revealed that textile wastewater was the main source of Sb. The distribution of Sb (0.48~21.4 μg/L) showed the least seasonal variation among the nine elements. Factor analysis revealed that the factor that controlled Sb distribution is unique. In general, Sb was more concentrated in the southeastern part of the study area where there was a large number of textile industries, and was affected by the specific conductivity and total dissolved solids in water ( < 0.01). Sb concentration in 35.71% of samples collected from the drainage outlet exceeded the standard limit of 10 μg/L. Results from three pollution assessment methods suggested that >5% of the sampling sites were slightly too heavily polluted and Sb contributed the most. Therefore, it is necessary to strengthen the administrative supervision of local textile enterprises and elevate the local standard of textile wastewater emission.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC9963225PMC
http://dx.doi.org/10.3390/ijerph20043600DOI Listing

Publication Analysis

Top Keywords

textile industries
8
surface water
8
potential toxic
8
toxic elements
8
textile wastewater
8
impact textile
4
industries surface
4
water contamination
4
contamination potential
4
elements case
4

Similar Publications

FeCoNiIrPtPd/NCNT exhibits 3.4- and 1.6-fold higher levels of mass activity than does commercial Pt/C in the hydrogen evolution reaction (HER) and ethanol oxidation reaction (EOR), respectively.

View Article and Find Full Text PDF

Introduction: Whether in industrial production or daily life, froth plays an important role in many processes. Sometimes, froth exists as a necessity and is also regarded as the typical characteristic of products, e.g.

View Article and Find Full Text PDF

Highly Antibacterial and Antifungal Cotton Fabric for Effective Odor Adsorption and Durable Waterproofing.

ACS Appl Mater Interfaces

January 2025

College of Biomass Science and Engineering, Key Laboratory of Biomass Fibers for Medical Care in Textile Industry, State Key Laboratory of Polymer Materials Engineering, Sichuan University, Chengdu 610065, China.

The demand for antibacterial, antifungal, and deodorant textiles has grown significantly with the increasing concern for health and hygiene. In this study, novel functional cotton fabric (EE) with long-lasting antibacterial, antifungal, and deodorant activity was prepared by graft modification with triclosan and eugenol. EE shows more than 99% antibacterial and antifungal activity against , , , and through mechanisms such as inhibiting enzyme activity and disrupting cell structure.

View Article and Find Full Text PDF

Liquid crystal sensor for Cr(III)-citrate detection via interfacial coagulation.

Anal Chim Acta

February 2025

Department of Chemistry, Tamkang University, New Taipei City, 25137, Taiwan. Electronic address:

Background: Trivalent chromium (Cr(III)) and its highly soluble carboxyl complexes, often discharged into the environment by industries such as electroplating, leather tanning, and textile manufacturing, present severe risks to human health and ecosystems due to their high toxicity. These compounds are notoriously difficult to detect and remove during wastewater treatment, as they can persist in aqueous environments. Consequently, there is a pressing need for the development of simple, cost-effective, and reliable methods for their detection, which can improve monitoring, facilitate timely interventions, and enhance environmental protection efforts.

View Article and Find Full Text PDF

In order to increase the added value of Xanthoceras Sorbifolia Bunge (XSB) and to obtain green biomass activated carbon with abundant pores for efficient MG removal, this study was the first to prepare XSB-based high-performance activated carbon using KOH activation. Activated at temperatures between 600 and 800 °C, XSBAC-800 exhibited the highest specific surface area (1580 m/g) and pore volume (0.732 cm/g), leading to superior MG adsorption.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!