Low-temperature direct synthesis of thick multilayered hexagonal-boron nitride (h-BN) on semiconducting and insulating substrates is required to produce high-performance electronic devices based on two-dimensional (2D) materials. In this study, multilayered h-BN with a thickness exceeding 5 nm was directly synthesized on quartz and Si at low temperatures, between 400 and 500 °C, by inductively coupled plasma-enhanced chemical vapor deposition using borazine as the precursor material. The quality and thickness of the h-BN crystals were investigated with respect to synthesis parameters, namely, temperature, radio frequency power, N flow rate, and H flow rate. Introducing N and H carrier gases critically affected the deposition rate, and increasing the carrier gas flow rate enhanced the h-BN crystal quality. The typical optical band gap of synthesized h-BN was approximately 5.8 eV, consistent with that of previous studies. The full width at half-maximum of the h-BN Raman peak was 32-33 cm, comparable to that of commercially available multilayered h-BN on Cu foil. These results are expected to facilitate the development of 2D materials for electronics applications.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC9933473 | PMC |
http://dx.doi.org/10.1021/acsomega.2c06757 | DOI Listing |
J Colloid Interface Sci
February 2025
Qianwan Institute, Ningbo Institute of Materials Technology and Engineering (NIMTE), Chinese Academy of Sciences, Ningbo 315201, PR China; Center of Materials Science and Optoelectronics Engineering, University of Chinese Academy of Sciences, Beijing 100049, PR China; Key Laboratory of Advanced Marine Materials, Ningbo Institute of Materials Technology and Engineering (NIMTE), Chinese Academy of Sciences, Ningbo 315201, PR China. Electronic address:
In this study, an economic and controllable Marangoni self-assembly approach is designed to prepare the heterostructured nanocoatings (8-28 nm) consisting of alternately stacked mosaic nanosheets of hexagonal boron nitride (h-BN) and graphene. The resulting 2D nanocoatings exhibit a combination of advantageous properties, such as prevention of interfacial reactions, robust interfacial binding, a labyrinthine barrier effect, inhibition of galvanic corrosion, and alleviation of internal stress. The protective property of graphene/h-BN heterostructured nanocoatings is studied through potentiodynamic polarization curves and electrochemical impedance spectroscopy, with the theoretical support of first-principles calculations.
View Article and Find Full Text PDFSmall
September 2024
Institute of Materials and Systems for Sustainability (IMaSS) & Department of Materials Chemistry, Nagoya University, Nagoya, 464-8601, Japan.
J Chem Phys
April 2024
Physikalische Chemie II, Friedrich-Alexander-Universität Erlangen-Nürnberg, Egerlandstraße 3, 91058 Erlangen, Germany.
Borazine is a well-established precursor molecule for the growth of hexagonal boron nitride (h-BN) via chemical vapor deposition on metal substrates. To understand the formation of the h-BN/Rh(111) moiré from borazine on a molecular level, we investigated the low-temperature adsorption and thermally induced on-surface reaction of borazine on Rh(111) in situ using synchrotron radiation-based high-resolution x-ray photoelectron spectroscopy (XPS), temperature-programmed XPS, and near-edge x-ray absorption fine structure measurements. We find that borazine adsorbs mainly as an intact molecule and have identified a flat-lying adsorption geometry.
View Article and Find Full Text PDFNanomaterials (Basel)
February 2024
State Key Laboratory of Radio Frequency Heterogeneous Integration, Shenzhen University, Shenzhen 518060, China.
Two-dimensional material indium selenide (InSe) holds great promise for applications in electronics and optoelectronics by virtue of its fascinating properties. However, most multilayer InSe-based transistors suffer from extrinsic scattering effects from interface disorders and the environment, which cause carrier mobility and density fluctuations and hinder their practical application. In this work, we employ the non-destructive method of van der Waals (vdW) integration to improve the electron mobility of back-gated multilayer InSe FETs.
View Article and Find Full Text PDFJ Phys Condens Matter
February 2024
Institute of Nano Science and Technology, Sector-81, Knowledge City, Sahibzada Ajit Singh Nagar, Mohali, Punjab 140306, India.
Low-dimensional piezoelectrics have drawn attention to the realization in nano-scale devices with high integration density. A unique branch of 2D Tellurene bilayers formed of weakly interacting quasi-1D chains via van der Waals forces is found to exhibit piezoelectricity due to the semiconducting band gap and spatial inversion asymmetry. Various bilayer stackings are systematically examined using density functional theory, revealing optimal piezoelectricity when dipole arrangements are identical in each layer.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!