Direct Tableting on a Continuous Manufacturing Line-Impact of Mixing Parameters, Material Densities, and Drug Load on Subsequent Process Parameters and Tablet Quality.

The continuous manufacturing (CM) of solid oral dosage forms has received increased attention in recent years and has become a leading technology in the pharmaceutical industry. A model has been developed based on process data from two design of experiments (DoEs), where the impact of the mixer process parameters, throughput (THR), hold up mass (HUM), impeller speed (IMP), and the input raw material bulk density (BD), on the continuous process and the resulting drug product has been investigated. These statistical models revealed equations, describing process parameter interactions for optimization purposes. For the exit valve opening width (EV) at the bottom of the continuous mixer (CMT), the combination of high throughput (30 kg/h) and low impeller speed (300 rpm) resulted in optimal process conditions. Apparent bulk density of the blend (BD) within the process, fill depth (FD), and tensile strength (TS) were mainly impacted by input bulk density (BD) of the tableting mixture, emphasizing the role of material attributes on the continuous manufacturing process. The apparent bulk density itself was, other than from the input bulk density, equally dependent from THR and IMP in opposite deflections. However, process parameters (THR and IMP) revealed a minor impact on the apparent BD compared to the input bulk density. FD was impacted mainly by THR ahead of IMP and the TS by IMP and THR to a similar extend, in opposite deflections. A simplified linear model to estimate the input bulk density revealed satisfactory prediction quality when included in the derived statistical model equations.