Heat flux systems for body core temperature assessment during exercise.

J Therm Biol

Ministry of Defense, Utrecht, the Netherlands.

Published: February 2023

Heat flux systems are increasingly used to assess core body temperature. However, validation of multiple systems is scarce. Therefore, an experiment was performed in which three commercially available heat flux systems (3 M, Medisim and Core) were compared to rectal temperature (T). Five females and four males performed exercise in a climate chamber set at 18 °C/50% relative humidity until exhaustion. Exercise duration was 36.3 ± 5.6 min (mean ± standard deviation). T in rest was 37.2 ± 0.3 °C. Medisim's-values were lower than T (36.9 ± 0.4 °C, p < 0.05); 3 M (37.2 ± 0.1 °C) and Core's (37.4 ± 0.3 °C) did not differ from T. Maximal temperatures after exercise were 38.4 ± 0.2 °C (T), 38.0 ± 0.4 °C (3 M), 38.8 ± 0.3 °C (Medisim) and 38.6 ± 0.3 °C (Core); Medisim was significantly higher than T (p < 0.05). The temperature profiles of the heat flux systems during exercise differed to varying degree from the rectal profiles; the Medisim system showed a faster increase during exercise than T (0.48 ± 0.25 °C in 20 min, p < 0.05), the Core system tended to show a systematic overestimation during the entire exercise period and the 3 M system showed large errors at the end of exercise, likely due to sweat entering the sensor. Therefore, the interpretation of heat flux sensor values as core body temperature estimates should be done with care; more research is required to elucidate the physiological significance of the generated temperature values.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.jtherbio.2023.103480DOI Listing

Publication Analysis

Top Keywords

heat flux
12
flux systems
12
systems
4
systems body
4
body core
4
core temperature
4
temperature assessment
4
assessment exercise
4
exercise heat
4
systems increasingly
4

Similar Publications

This study investigates a comprehensive enhancement strategy for photovoltaic (PV) panel efficiency, focusing on increasing electrical output through the integration of parabolic reflectors, advanced cooling mechanisms, and thermoelectric generation. Parabolic reflectors are implemented in the system to maximize solar irradiance on the PV panel's surface, while a specialized cooling system is introduced to regulate temperature distribution across the silicon layer. This cooling system consists of a finned duct filled with paraffin (RT35HC) and enhanced with SWCNT nanoparticles, which improve the thermal properties of the paraffin, facilitating more effective heat dissipation.

View Article and Find Full Text PDF

Measurement of divertor surface heat flux by infra-red thermographic inversion in ST40.

Rev Sci Instrum

January 2025

Plasma Prediction and Simulation Department, Tokamak Energy Ltd., 173 Brook Drive, Milton Park, Abingdon OX14 4SD, United Kingdom.

Diagnostic tools for understanding the edge plasma behavior in fusion devices are essential. The main focus of the present work is to present the infra-red (IR) diagnostics installed on Tokamak Energy's spherical tokamak (ST40) and the IR thermographic inversion tool, Functional Analysis of Heat Flux (FAHF). FAHF is designed for multi-2D thermographic inversions within the divertor tiles using the finite difference method and an explicit time stepping scheme.

View Article and Find Full Text PDF

Climate change is among the greatest threats to health in the 21st century, requiring the urgent scaling-up of adaptation interventions. We aim to summarise adaptation interventions that were funded by the Belmont Forum and the European Union, the largest global funders of climate change and health research. A systematic search was conducted (updated February 2023) to identify articles on adaptation interventions for health within this funding network.

View Article and Find Full Text PDF

Spectral heat flux redistribution upon interfacial transmission.

J Phys Condens Matter

January 2025

Department of Mechanical Engineering, University of Nevada, Reno, 1664 N. Virginia Street, Reno, Nevada, 89557-0312, UNITED STATES.

In nonmetallic crystals, heat is transported by phonons of different frequencies, each contributing differently to the overall heat flux spectrum. In this study, we demonstrate a significant redistribution of heat flux among phonon frequencies when phonons transmit across the interface between dissimilar solids. This redistribution arises from the natural tendency of phononic heat to re-establish the bulk distribution characteristic of the material through which it propagates.

View Article and Find Full Text PDF

Dropwise condensation (DWC) is a widely studied vapor-liquid phase-change process that has attracted significant research attention due to its exceptional energy transfer efficiency. Therefore, it is highly important to predict the heat transfer rate during DWC and the factors that affect it. This study presents a computational fluid dynamics (CFD) investigation on DWC heat transfer under diverse circumstances for a single droplet on inclined and rough surfaces with Wenzel structure.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!