Electronic tuning of Ni-Fe-Co oxide/hydroxide as highly active electrocatalyst for rechargeable Zn-air batteries.

As a bifunctional oxygen electrocatalyst (oxygen reduction reaction (ORR) and oxygen evolution reaction (OER)), spinel copper cobaltite (CuCoO) is attracting significant research interest owing to the tailored Co, Cu electronic structure and ease of adjusting the electrochemically active area. However, its poor OER performance (>300 mV at 10 mA cm) limits its practical application for rechargeable zinc-air batteries. Therefore, we construct a CuCoO/NiFe LDH oxide/hydroxide interface to tune the properties of Ni, Fe and Co for enhancing OER activity and decreasing the charging overpotential of rechargeable zinc-air batteries. The obtained electrocatalysts show a low overpotential of 251 mV (10 mA cm), which is 91 mV lower than the overpotential (342 mV) of CuCoO. By Raman, XPS and electrochemical analyses, we ascribe the enhanced OER activity to the increasing Ni/Fe oxidation state triggered by the charge transfer of Ni/Fe and Co, which prompts CuCoO/NiFe LDH to rapidly form an active surface layer. Benefiting from enhanced OER performance, zinc-air batteries with a CuCoO/NiFe LDH electrode display a high round-trip efficiency with a low voltage gap of ∼0.78 V (10 mA cm) due to the obvious decrease in the charging overpotential. These results suggest the importance of tuning the charge transfer on interfaces for designing high-efficiency electrocatalysts.