During the storage of celluloid pictures for animation films over half a century, an interleave paper adhered to acrylic paint. The purpose of this study is to establish a methodology to cleanly remove the paper from the paint. A layered film, a replica of the celluloid pictures, adhered with paper was prepared and immersed in water or ethanol. The effect of these solvents on the peeling behavior was investigated using a peel test. The maximum peel force for the dry layered film in was distributed at ~0.5 N, independently of the peel speed. The peel force was significantly reduced after the layered film was immersed in pure water or ethanol. A morphological observation revealed that the dry paper was peeled off via the cohesive failure of the paper. After the layered film was immersed in pure water, the paper was also peeled off via cohesive failure. The layered film immersed in ethanol was peeled off at the paper/paint interface. To clear the effect of the volume change in the paint on peel behavior, the relative volume was determined via image analysis. The relative volume of paint was 1.56 in pure water and 1.37 in ethanol. It can be considered that the large difference in the volume of paint induces a large shear stress at the paint/paper interface.
Download full-text PDF |
Source |
|---|---|
| http://www.ncbi.nlm.nih.gov/pmc/articles/PMC9919076 | PMC |
| http://dx.doi.org/10.3390/polym15030690 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Running-In Behavior and Failure Mechanism Between AgCuNi Alloy and Au-Electroplated Layer.
Sensors (Basel)
December 2024
State Key Laboratory of Tribology in Advanced Equipment, Tsinghua University, Beijing 100084, China.
To avoid wear and tear of the slip ring due to electrical corrosion, the slip ring needs to undergo the running-in process under atmospheric conditions without current after assembly. To address the urgent demand for long-service capability space conductive slip rings in the aerospace field, the running-in behavior and failure mechanism between the AgCuNi alloy and Au-electroplated layer are investigated using a ball-on-disc tribometer in this paper. The results show that the transfer film composed of Au plays an important role in modifying the friction during the sliding process.
View Article and Find Full Text PDFBiocomposite Active Whey Protein Films with Thyme Reinforced by Electrospun Polylactic Acid Fiber Mat.
Foods
January 2025
Center of Excellence Polymer Processing, Faculty of Engineering, Dunarea de Jos University of Galați, Domnească Street, No. 111, 800201 Galați, Romania.
Electrospinning is a versatile technique for obtaining nano/micro fibers which are able to significantly change the active properties of composite materials and bring in new dimensions to agri-food applications. Composite bio-based packaging materials obtained from whey proteins, functionalized with thyme essential oil (TEO) and reinforced by electrospun polylactic acid (PLA) fibers, represent a promising solution for developing new active food packaging using environmentally friendly materials. The aim of this study is to obtain and characterize one-side-active composite films covered with a PLA fiber mat: (i) WF/G1, WF/G2, and WF/G3 resulting from electrospinning with one needle at different electrospinning times of 90, 150, and 210 min, respectively, and (ii) WF/G4 obtained with two face-to-face needles after 210 min of electrospinning.
View Article and Find Full Text PDFMultilayer Graphene Stacked with Silver Nanowire Networks for Transparent Conductor.
Materials (Basel)
January 2025
Department of Physics, Changwon National University, Changwon 51140, Republic of Korea.
A mechanically robust flexible transparent conductor with high thermal and chemical stability was fabricated from welded silver nanowire networks (w-Ag-NWs) sandwiched between multilayer graphene (MLG) and polyimide (PI) films. By modifying the gas flow dynamics and surface chemistry of the Cu surface during graphene growth, a highly crystalline and uniform MLG film was obtained on the Cu foil, which was then directly coated on the Ag-NW networks to serve as a barrier material. It was found that the highly crystalline layers in the MLG film compensate for structural defects, thus forming a perfect barrier film to shield Ag NWs from oxidation and sulfurization.
View Article and Find Full Text PDFW/WO/TiO Multilayer Film with Elevated Electrochromic and Capacitive Properties.
Materials (Basel)
January 2025
College of Physics and Electronic Information, Shandong Key Laboratory of Biophysics, Dezhou University, Dezhou 253023, China.
Electrochromic capacitors, which are capable of altering their appearances in line with their charged states, are drawing substantial attention from both academia and industry. Tungsten oxide is usually used as an electrochromic layer material for electrochromic devices, or as an active material for high-performance capacitor electrodes. Despite this, acceptable visual aesthetics in electrochromic capacitors have almost never been achieved using tungsten oxide, because, in its pure form, this compound only displays a onefold color modulation from transparent to blue.
View Article and Find Full Text PDFStudy on Quantitative Adjustment of CD Bias and Profile Angle in the Wet Etching of Cu-Based Stacked Electrode.
Materials (Basel)
December 2024
Chongqing Key Laboratory of Interface Physics in Energy Conversion, College of Physics, Chongqing University, Chongqing 400044, China.
The electrodes of thin film transistors (TFTs) have evolved from conventional single Cu layers to multi-layered structures formed by Cu and other metals or alloys. Different etching rates of various metals and galvanic corrosion between distinct metals may cause etching defects such as rough or uneven cross-sectional surfaces of stacked electrodes. Therefore, the etching of stacked electrodes faces new challenges.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!