Monitoring of the presence of plasticizers and effect of temperature and storage time in bottled water using a green liquid-liquid microextraction method.

Food Res Int

Departamento de Química, Unidad Departamental de Química Analítica, Facultad de Ciencias, Universidad de La Laguna (ULL), Avenida Astrofísico Francisco Sánchez, s/n°, 38206 San Cristóbal de La Laguna, Tenerife, Spain. Electronic address:

Published: February 2023

AI Article Synopsis

  • A natural deep eutectic solvent was utilized for extracting 14 phthalates and one adipate from bottled waters, achieving high extraction efficiency and low limits of quantification.
  • The study validated the extraction method, confirming effective recovery rates and strong determination coefficients under optimal conditions.
  • Results indicated that temperature and storage time did not significantly affect plasticizer presence, suggesting contamination is likely introduced during production or water supply rather than from storage conditions.

Article Abstract

In this work, a natural deep eutectic solvent was used for the liquid-liquid microextraction of fourteen phthalates and one adipate from bottled waters. The methodology was validated in terms of matrix effect, linearity, recovery, and limits of quantification (LOQs). Optimum extraction conditions (10 mL of water at pH 8.0 with 100 μL of thymol: menthol 2:1 (n/n) as solvent) provided satisfactory determination coefficients (≥ 0.9977), recovery values (82-127%), and LOQs (0.018-0.523 μg/L). The effects of temperature and storage time on plasticizer presence were studied for 36 different brands stored at 4 °C, room temperature, and 45 °C, and analyzed at 0, 24, 48, 72 h, and 1 week. Only diethyl-, dibutyl-, bis-(2-ethylhexyl) phthalates, and bis-(2-ethylhexyl) adipate were detected. The results showed that there is no relationship between the storage conditions, the bottle material or water carbonation, and the occurrence of these plasticizers, suggesting that residues are introduced during production or by the water supply. The estimated daily intake was lower than the total daily intake set by the European Food Safety Authority.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.foodres.2022.112424DOI Listing

Publication Analysis

Top Keywords

temperature storage
8
storage time
8
liquid-liquid microextraction
8
daily intake
8
monitoring presence
4
presence plasticizers
4
plasticizers temperature
4
time bottled
4
water
4
bottled water
4

Similar Publications

Mitigating anthropogenic climate change with aqueous green energy.

Sci Rep

January 2025

School of Earth and Ocean Sciences, University of Victoria, PO Box 1700, Victoria, BC, V8W 2Y2, Canada.

Reaching net zero emissions and limiting global warming to 2 °C requires the widespread introduction of technology-based solutions to draw down existing atmospheric levels and future emissions of CO. One such approach is direct air CO capture and storage (DACCS), a readily available, yet energy-intensive process. The combination of DACCS and ocean thermal energy conversion (OTEC) allows for independently powered carbon capture plants to inject concentrated carbon into deep marine sediments where storage is generally safe and permanent.

View Article and Find Full Text PDF

Ancestral carbonic anhydrase with significantly enhanced stability and activity for CO capture and utilization.

Bioresour Technol

January 2025

Department of Bioengineering and Biotechnology, Huaqiao University, Xiamen 361021, Fujian Province, PR China. Electronic address:

Carbonic anhydrases (CAs) has garnered increasing attention in carbon capture, utilization and storage (CCUS) due to their ecological friendliness. However, most of them suffer susceptibility to deactivation in harsh conditions. Herein, a reliable dataset was adopted for creating ancestral CAs through an optimized ancestral sequence reconstruction (ASR) method.

View Article and Find Full Text PDF

Construction of Supramolecular Polymer Network Elastomers Based on Pillar[5]arene/Alkyl Chain Host-Guest Interactions.

ACS Macro Lett

January 2025

Key Laboratory of Materials Chemistry for Energy Conversion and Storage, Ministry of Education, Hubei Key Laboratory of Materials Chemistry and Service Failure, Hubei Engineering Research Center for Biomaterials and Medical Protective Materials, State Key Laboratory of Materials Processing and Die & Mould Technology, School of Chemistry and Chemical Engineering, Huazhong University of Science and Technology, Wuhan 430074, China.

As a special kind of supramolecular compound with many favorable properties, pillar[]arene-based supramolecular polymer networks (SPNs) show potential application in many fields. Although we have come a long way using pillar[]arene to prepare SPNs and construct a series of smart materials, it remains a challenge to enhance the mechanical strength of pillar[]arene-based SPNs. To address this issue, a new supramolecular regulation strategy was developed, which could precisely control the preparation of pillar[]arene-based SPN materials with excellent mechanical properties by adjusting the polymer network structures.

View Article and Find Full Text PDF

Room-Temperature CsPbI-Quantum-Dot Reinforced Solid-State Li-Polymer Battery.

Small

January 2025

Key Laboratory of Advanced Technologies of Materials, Ministry of Education, School of Materials Science and Engineering, Southwest Jiaotong University, Chengdu, 610031, China.

A novel polymer electrolyte based on CsPbI quantum dots (QDs) reinforced polyacrylonitrile (PAN), named as PIL, is exploited to address the low room-temperature (RT) ion conductivity and poor interfacial compatibility of polymer solid-state electrolytes. After optimizing the content of CsPbI QDs, RT ion conductivity of PIL largely increased from 0.077 to 0.

View Article and Find Full Text PDF

This research aimed to evaluate the use of edible coating from a combination of liquid smoke and turmeric extract as a preservative for mackerel at room temperature. Liquid smoke was obtained from the pyrolysis of oil palm empty fruit bunches (OPEFB) at a temperature of 380 °C and purified by distillation at 190 °C. Liquid smoke with a concentration of 3% was combined with turmeric extract at a ratio of 2, 4, 6, and 8 g/L (CLS 2:1, CLS 4:1, CLS 6:1 and CLS 8:1).

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!