In the case of concrete sustainability, two main ways are generally discussed: (1) the reduction of natural raw materials and (2) the reduction of emissions related to concrete production. Following the second point, there have not yet been reported clear results. This problem is not given enough attention in present publications. This study brings a general view of this issue and a basic comparison with common concrete and traditional reinforcement. This case study deals with the life cycle analysis of a concrete slab made of recycled aggregate concrete with a fine recycled aggregate. The concrete slab was designed according to the limit states of load-bearing capacity and serviceability, which is based on the experimental verification of recycled aggregate concrete properties. Two different reinforcements are compared: (1) ordinary reinforcement by steel bars and (2) glass fibers. Furthermore, scenarios vary due to the slab thickness and reinforcement percentage. The results show the positive environmental impact of replacing natural sand with a fine recycled aggregate. The reduction of climate change potential can be almost 40% in some cases.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC9863802PMC
http://dx.doi.org/10.3390/ma16020616DOI Listing

Publication Analysis

Top Keywords

recycled aggregate
20
aggregate concrete
16
concrete slab
12
concrete
9
environmental impact
8
slab recycled
8
limit states
8
states load-bearing
8
load-bearing capacity
8
case study
8

Similar Publications

Enhancing visible light degradation of gaseous formaldehyde with CuO/OVs-TiO photocatalyst loaded wallpaper: Preparation, efficacy and mechanism.

Chemosphere

January 2025

Beijing Key Laboratory for Source Control Technology of Water Pollution, Engineering Research Center for Water Pollution Source Control and Eco-remediation, Beijing Forestry University, Beijing, 100083, China. Electronic address:

Photocatalytic oxidation is considered to be a highly promising technology for indoor formaldehyde (HCHO) abatement. However, powdered photocatalysts encounter practical challenges due to their recycling difficulties and propensity for aggregation. In this study, we developed a CuO/OVs-TiO photocatalyst dispersion using various physical and chemical methods, which could be stabilized for an extended period.

View Article and Find Full Text PDF

In agricultural and waste management systems, dairy manure wastewater is often recycled for irrigation. However, a key challenge lies in handling suspended solids (SS) and effectively dewatering sludge. To address this, an innovative polycationic soybean protein-based flocculant (SPI+) was developed and applied to enhance flocculation and sludge dewatering efficiency.

View Article and Find Full Text PDF

Management of wind-turbine blade waste as high-content concrete addition: Mechanical performance evaluation and life cycle assessment.

J Environ Manage

January 2025

Department of Civil Engineering, Escuela Politécnica Superior, University of Burgos, c/ Villadiego s/n, 09001, Burgos, Spain. Electronic address:

The management of end-of-life wind-turbine blades in the coming years will be necessary, as a clear solution for their recycling is yet to be found due to their complex composition. The suitability of their mechanical recycling is therefore evaluated in this paper, obtaining Raw-Crushed Wind-Turbine Blade (RCWTB) for subsequent incorporation in high amounts of up to 10% vol. in concrete, replacing the aggregates to achieve Fiber-Reinforced Concrete (FRC).

View Article and Find Full Text PDF

This study introduces an innovative approach to enhancing recycled aggregate concrete (RAC) by incorporating nanosilica (NS) and natural fibers (NF), specifically sisal fiber (SF) and palm fiber (PF). This novel combination aims to overcome the inherent limitations of RAC, such as reduced strength and durability, while promoting sustainability in construction. The research focuses on evaluating the mechanical properties of RAC, including compressive and flexural strengths, through the integration of NS and NF.

View Article and Find Full Text PDF

The contamination levels of recycled aggregates from construction and demolition waste in compliance with Italian and Spanish regulations.

Environ Sci Pollut Res Int

January 2025

Department of Civil, Environmental, Architectural Engineering and Mathematics, University of Brescia, Via Branze 43, 25123, Brescia, Italy.

The aim of this study is to perform a comparative analysis of Italian and Spanish regulations for construction and demolition (C&D) waste management, to produce recycled aggregates (RAs). Furthermore, this study seeks to compare the results derived from the examination of leaching test results from RAs collected in both countries to identify the most critical pollutants. Our research involved a comprehensive comparison and analysis of waste management regulations in Italy and Spain, highlighting both commonalities and disparities.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!