The MIL100(Fe)/BaTiZrO nanocomposite with the photocatalytic capability for study of tetracycline photodegradation kinetics.

Spectrochim Acta A Mol Biomol Spectrosc

Department of Chemistry, Faculty of Science, University of Jiroft, Jiroft, P. O. Box 7867161167, Iran.

Published: April 2023

The visible light-active nanocomposite with the photocatalytic capability was facile one-pot solvothermal method successfully synthesized. X-ray diffraction (XRD), Thermogravimetry and Derivative Thermogravimetry (TG-DTG), Scanning Electron Microscopy with Energy Dispersive X-ray Analysis (SEM-EDX), Diffuse Reflectance Spectroscopy (UV-Vis DRS), and Fourier Transform Infra-Red (FT-IR) analysis were employed to characterize the synthetized BaTiZrO3, MIL-100(Fe), and the MIL-100(Fe)/BaTiZrO samples. As a result of the Scherrer equations, the size of grains for MIL-100(Fe), BaTiZrO, and MIL-100(Fe)/BaTiZrO was estimated to be 40.81, 12.00, and 22.70 nm, respectively. MIL-100(Fe), BaTiZrO, and MIL-100(Fe)/BaTiZrO samples showed bandgap values of 1.77, 3.02, and 2.56 determined from their absorption edge wavelengths. In the photodegraded solutions, chemical oxygen demand (COD) data and tetracycline (TC) absorbencies were used to obtain the rate constants of 0.032 min and 0.030 min, respectively. This corresponds to t-values of 27.7 min and 21.7 min, respectively, for the degradation and mineralization of TC molecules during photodegradation process.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.saa.2023.122323DOI Listing

Publication Analysis

Top Keywords

nanocomposite photocatalytic
8
photocatalytic capability
8
mil-100fe/batizro samples
8
mil-100fe batizro
8
batizro mil-100fe/batizro
8
mil100fe/batizro nanocomposite
4
capability study
4
study tetracycline
4
tetracycline photodegradation
4
photodegradation kinetics
4

Similar Publications

A simple and inexpensive process from natural phosphate in the presence of Ag ions was used to develop AgO-loaded hydroxyapatite nanocomposites. The structural and textural characterization of the nanocomposites suggests that the AgO nanoparticles are well dispersed on the hydroxyapatite (HAp). The prepared nanocomposites show efficient Rhodamine B (RhB) dye photocatalytic degradation in water under visible and UV-visible light irradiation.

View Article and Find Full Text PDF

A poly(vinyl alcohol)/montmorillonite/titania (PVA/MMT/TiO) nanocomposite film was fabricated via a simple solution casting strategy for the removal of cationic as well as anionic dyes. The developed nanocomposite film was subjected to X-ray diffraction (XRD), Fourier transform Infrared (FTIR), thermogravimetric analysis, dynamic mechanical analysis (DMA), mechanical property evaluation, and scanning electron microscopy (SEM) analysis. The embedding of MMT and TiO nanoparticles onto a PVA matrix has been confirmed from XRD, FTIR, and SEM analysis.

View Article and Find Full Text PDF

This study presents the development and characterization of manganese ferrite (MnFeO)-based nanocomposites with graphite oxide (GO) and chitosan (CS) for efficient dye removal from textile wastewater and aqueous solution. Comprehensive characterization was performed using FT-IR, Raman, XRD, BET, SEM, DRS and Zeta potential techniques. XRD analysis confirmed the cubic spinel structure of MnFeO, with characteristic peaks at 2θ = 32, 35, 48, 53, 62, and 64°.

View Article and Find Full Text PDF

In this study, we report the synthesis and photocatalytic performance of Co₃O₄-decorated hexagonal boron nitride (hBN) composites for degrading methylene blue (MB) and ibuprofen (IBF) under sunlight irradiation. Using a dry impregnation method, the composites were prepared with varying Co₃O₄ loadings (0.5%, 1%, 2%).

View Article and Find Full Text PDF

The world is now facing a water scarcity crisis due to waste, pollution, and uneven distribution of freshwater resources, which are limited. Thus, the creation of innovative, economical, and effective methods for purifying water is crucial. Here, the photo-assisted degradation of methylene blue (MB) dye under visible light and UV was achieved by using RGO photocatalyst loaded with ZnCuFeO in three different loaded 10%, 20%, and 30% called MRGO 10, MRGO 20, and MRGO 30.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!