Secondary problems, such as the occurrence of side reactions and the accumulation of by-products, are a major challenge in the application of wet denitrification technology through urea solution. We revealed the formation mechanism of urea nitrate and clarified the main and side reaction paths and key intermediates of denitrification. Urea nitrate would be separated from urea absorption solution only when the concentration product of [urea], [H] and [NO] was greater than 0.87~1.22 mol/L. The effects of the urea concentration (5-20%) and reaction temperature (30-70 °C) on the denitrification efficiency could be ignored. Improving the oxidation degree of the flue gas promoted the removal of nitrogen oxides. The alkaline condition was beneficial to the dissolution process, while the acidic condition was beneficial to the reaction process. As a whole, the alkaline condition was the preferred process parameter. The research results could guide the optimization of process conditions in theory, improve the operation efficiency of the denitrification reactor and avoid the occurrence of side reactions.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC9822094PMC
http://dx.doi.org/10.3390/molecules28010162DOI Listing

Publication Analysis

Top Keywords

urea solution
8
main side
8
side reaction
8
reaction paths
8
occurrence side
8
side reactions
8
urea nitrate
8
alkaline condition
8
condition beneficial
8
urea
6

Similar Publications

Bio-nanomaterials are gaining increasing attention due to their renewable and eco-friendly characteristics. Among these, nanocrystalline cellulose (NCC) stands out as one of the most advanced materials for applications in food, healthcare, composite production, and beyond. In this study, NCC was successfully extracted from cotton-based textile waste using a combination of chemical and mechanical methods.

View Article and Find Full Text PDF

Animal as the Solution II: Phenotyping for Low Milk Urea Nitrogen A1PF Dairy Cows.

Animals (Basel)

December 2024

Department of Agricultural Sciences, Faculty of Agricultural and Life Sciences, Lincoln University, Lincoln, P.O. Box 85084, Christchurch 7647, New Zealand.

The societal pressure on intensive pastoral dairying demands the search for strategies to reduce the amount of N flowing through and excreted by dairy cows. One of the strategies that is being currently explored focuses on the animal as a solution, as there are differences in N metabolism between cows even within the same herd. This work was conducted to explore such an approach in A1PF herds in New Zealand and the possibility of identifying A1PF cows that are divergent for milk urea nitrogen (MUN) concentration through phenotyping as a potential viable strategy to reduce N leaching and emissions from temperate dairy systems.

View Article and Find Full Text PDF

The quest for highly efficient electrocatalysts for direct urea fuel cells (DUFCs) is vital in addressing the energy deficits and environmental crisis. Ni-based LDHs are widely known for their substantial capability in urea oxidation reactions (UOR). This study involved the synthesis of NiCr-LDH/VC MXene nanocomposites (NCVs) and the evaluation of their electrochemical efficiency towards UOR.

View Article and Find Full Text PDF

[Protective effect of tumor necrosis factor receptor-associated factor 6 inhibitor C25-140 on acute kidney injury induced by diquat poisoning in mice].

Zhonghua Wei Zhong Bing Ji Jiu Yi Xue

December 2024

Department of Emergency, Kweichow Moutai Hospital, Renhuai 564500, Guizhou, China. Corresponding author: Ou Renyang, Email:

Objective: To investigate the protective effect and mechanism of tumor necrosis factor receptor-associated factor 6 (TRAF6) inhibitor C25-140 on acute kidney injury (AKI) induced by acute diquat (DQ) poisoning in mice.

Methods: A total of 80 SPF grade healthy male C57BL/6 mice were randomly divided into the normal control group, DQ model group, C25-140 intervention group, and C25-140 control group, with 20 mice in each group. The DQ poisoning mouse model was established by using one-time intraperitoneal injection of 1 mL of 40 mg/kg DQ solution.

View Article and Find Full Text PDF

Cellulose microgel beads fabricated using the dropping technique suffer from structural irregularity and mechanical variability. This limits their translation to biomedical applications that are sensitive to variations in material properties. Ionic salts are often uncontrolled by-products of this technique, despite the known effects of ionic salts on cellulose assembly.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!