Influence of Microstructure on Dynamic Mechanical Behavior and Damage Evolution of Frozen-Thawed Sandstone Using Computed Tomography.

Frost-induced microstructure degradation of rocks is one of the main reasons for the changes in their dynamic mechanical behavior in cold environments. To this end, computed tomography (CT) was performed to quantify the changes in the microstructure of yellow sandstone after freeze-thaw (F-T) action. On this basis, the influence of the microscopic parameters on the dynamic mechanical behavior was studied. The results showed that the strain rate enhanced the dynamic mechanical properties, but the F-T-induced decrease in strength and elastic modulus increased with increasing strain rate. After 40 F-T cycles, the dynamic strength of the samples increased by 41% to 75.6 MPa when the strain rate was increased from 75 to 115 s, which is 2.5 times the static strength. Moreover, the dynamic strength and elastic modulus of the sample were linearly and negatively correlated with the fractal dimension and porosity, with the largest decrease rate at 115 s, indicating that the microscopic parameters have a crucial influence on dynamic mechanical behavior. When the fractal dimension was increased from 2.56 to 2.67, the dynamic peak strength of the samples under the three impact loads decreased by 43.7 MPa (75 s), 61.8 MPa (95 s), and 71.4 MPa (115 s), respectively. In addition, a damage evolution model under F-T and impact loading was developed considering porosity variation. It was found that the damage development in the sample was highly related to the strain rate and F-T damage. As the strain rate increases, the strain required for damage development gradually decreases with a lower increase rate. In contrast, the strain required for damage development in the sample increases with increasing F-T damage. The research results can be a reference for constructing and maintaining rock structures in cold regions.