The Timepix (TPX) is a position- and time-sensitive pixelated charge detector that can be coupled with time-of-flight mass spectrometry (TOF MS) in combination with microchannel plates (MCPs) for the spatially and temporally resolved detection of biomolecules. Earlier generation TPX detectors used in previous studies were limited by a moderate time resolution (at best 10 ns) and single-stop detection for each pixel that hampered the detection of ions with high mass-to-charge (/) values at high pixel occupancies. In this study, we have coupled an MCP-phosphor screen-TPX3CAM detection assembly that contains a silicon-coated TPX3 chip to a matrix-assisted laser desorption/ionization (MALDI)-axial TOF MS. A time resolution of 1.5625 ns, per-pixel multihit functionality, simultaneous measurement of TOF and time-over-threshold (TOT) values, and kHz readout rates of the TPX3 extended the / detection range of the TPX detector family. The detection of singly charged intact Immunoglobulin M ions of / value approaching 1 × 10 Da has been demonstrated. We also discuss the utilization of additional information on impact coordinates and TOT provided by the TPX3 compared to conventional MS detectors for the enhancement of the quality of the mass spectrum in terms of signal-to-noise (S/N) ratio. We show how the reduced dead time and event-based readout in TPX3 compared to the TPX improves the sensitivity of high / detection in both low and high mass measurements (/ range: 757-970,000 Da). We further exploit the imaging capabilities of the TPX3 detector for the spatial and temporal separation of neutral fragments generated by metastable decay at different locations along the field-free flight region by simultaneous application of deflection and retarding fields.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC9850352PMC
http://dx.doi.org/10.1021/acs.analchem.2c04480DOI Listing

Publication Analysis

Top Keywords

high mass
8
matrix-assisted laser
8
laser desorption/ionization
8
time-of-flight mass
8
mass spectrometry
8
time resolution
8
tpx3 compared
8
detection
7
high
5
mass
5

Similar Publications

Infective endocarditis carries a high risk of morbidity and mortality with recurrent infections and non-compliance. In the case of right-sided endocarditis, the indications for intervention are less clear. The Angiovac procedure provides a treatment for right-sided endocarditis that is a less-invasive and ideal for a complicated patient population.

View Article and Find Full Text PDF

Otherwise, inoperable. The role of ECMO in thoracic surgery - focus on the mediastinum.

Port J Card Thorac Vasc Surg

January 2025

Thoracic surgeon, Fondazione IRCCS Ca' Granda Ospedale Maggiore Policlinico, Milano, Italy.

The use of extracorporeal membrane oxygenation (ECMO) in surgery is expanding as the medical community started adopting it, with good results, for procedures with high risk of respiratory and hemodynamic instability. This technique provided the possibility to reduce the number of patients previously considered inoperable because of these limitations. Thymic epithelial tumors (TETs) are rare neoplastic mediastinal lesions, with a reported incidence of 0.

View Article and Find Full Text PDF

Background: Obesity is a risk factor for heart failure (HF) development but is associated with a lower incidence of mortality in HF patients. This obesity paradox may be confounded by unrecognized comorbidities, including cachexia.

Methods: A retrospective assessment was conducted using data from a prospectively recruiting multicenter registry, which included consecutive acute heart failure patients.

View Article and Find Full Text PDF

High-temperature structural disorders stabilize hydrous aluminosilicates in the mantle transition zone.

Nat Commun

January 2025

Center for High Pressure Science, State Key Laboratory of Metastable Materials Science and Technology, Yanshan University, Qinhuangdao, 066004, China.

Hydrous aluminosilicates are important deep water-carriers in sediments subducting into the deep mantle. To date, it remains enigmatic how hydrous aluminosilicates withstand extremely high temperatures in the mantle transition zone. Here we systematically investigate the crystal structures and chemical compositions of typical hydrous aluminosilicates using single-crystal X-ray diffraction, electron probe microanalyzer, and nanoscale secondary ion mass spectrometry.

View Article and Find Full Text PDF

Time Code for multifunctional 3D printhead controls.

Nat Commun

January 2025

Department of Civil and Systems Engineering, Johns Hopkins University, Baltimore, MD, USA.

Direct Ink Writing, an extrusion-based 3D printing technique, has attracted growing interest due to its ability to process a broad range of materials and integrate multifunctional printheads with features such as shape-changing nozzles, in-situ curing, material switching, and material mixing. Despite these advancements, incorporating auxiliary controls into Geometry Code (G-Code), the standard programming language for these printers, remains challenging. G-Code's line-by-line execution requires auxiliary control commands to interrupt the print path motion, causing defects in the printed structure.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!