Accuracy of Lateral Mass Screw Insertion during Cervical Spine Surgery without Fluoroscopic Guidance and Comparison of Postoperative Screw Loosening Rate among Unicortical and Bicortical Screws Using Computed Tomography.

Introduction: Pedicle screws (PSs) or lateral mass screws (LMSs) are used in posterior cervical spine fixation. The former are more firmly fixed but are associated with the risk of neurovascular injury and should be inserted using intraoperative imaging or navigation, which may prolong the surgical duration and is not feasible in all hospitals. This prospective clinical study aimed to evaluate the outcomes of LMS insertions without fluoroscopic guidance and screw loosening rates at 6 months postoperatively using computed tomography (CT).

Methods: We examined 38 patients who underwent posterior cervical spine fusion using 206 LMSs in the C3-C6 range between January 2018 and July 2021. The direction of screw insertion followed the Magerl method, and we inserted screws as bicortically as possible without intraoperative imaging. The screw position was examined using CT at 1 week postoperatively. Screw insertion angles, bicortical insertion rate, facet violation, and neurovascular injury were evaluated. Screw loosening with unicortical and bicortical screws (US and BS, respectively) was investigated using CT at 6 months postoperatively.

Results: The average LMS length was 14.1 mm. The average axial and sagittal angles were 33.9° and 29.2°, respectively. Among the 206 LMSs inserted, 167 were BS; of these, 94.6% had screw length protrusion of 0-2 mm. Facet violation was observed in 3.4% of all screws but without neurovascular injury. Six months postoperatively, loosening of 25 screws (12.1%) occurred, including 17 (18.3%) USs and 8 (8.39%) BSs. The screw loosening rate was significantly higher in US than for BS (43.6% [17/39] vs. 4.8% [8/167], P<0.01).

Conclusions: Over 80% of LMSs were inserted bicortically without intraoperative imaging. By devising the screw length selection process, we inserted for screw loosening was more common in US and more likely at the fixed end.