Experimental and simulation investigation of surgical needle insertion into soft tissue mimic biomaterial for minimally invasive surgery (MIS).

The surgical needle insertion process is widely applied in medical interference. During the insertion process, the inhomogeneity and denseness of the soft tissues make it tough to detect the essential tissue damage, a rupture occurs that contains huge forces and material deformations. This study is very important, as all the above-mentioned factors are very significant for modern invasive surgery so that the success rate of the surgery can increase and the patient recovers smoothly. This investigation intends to perform minimally invasive surgical (MIS) procedures and reduce the living tissue damage while performing the biopsy, PCNL, etc. A fracture mechanics method was analyzed to create a needle insertion model which can estimate the needle insertion force during inset in tissue-like PVA gel. The force model was calculated by needle insertion experimentally, and also estimated the needle tip geometry, and diameter influences the fracture toughness. Validate exp. results with simulation results and other papers. It is observed that needle diameter has a significant effect on fracture toughness, whereas the insertion velocity has a slight impact on the fracture toughness. During the rotational needle insertion process, the winds-up of the gel occurs and the diameter of the hole was increasing with increased rpm. Maximum insertion force was noticed in the 27 G needle at 5 mm/s. The interaction function will be less at the maximum fracture development region.