Exact solutions for viscous Marangoni spreading.

Phys Rev E

University of Lyon, Université Claude Bernard Lyon 1, CNRS, Institut Lumière Matière, F-69622 Villeurbanne, France.

Published: October 2022

When surface-active molecules are released at a liquid interface, their spreading dynamics is controlled by Marangoni flows. Though such Marangoni spreading was investigated in different limits, exact solutions remain very few. Here we consider the spreading of an insoluble surfactant along the interface of a deep fluid layer. For two-dimensional Stokes flows, it was recently shown that the nonlinear transport problem can be exactly mapped to a complex Burgers equation [D. Crowdy, SIAM J. Appl. Math. 81, 2526 (2021)]SMJMAP0036-139910.1137/21M1400316. We first present a very simple derivation of this equation. We then provide fully explicit solutions and find that varying the initial surfactant distribution-pulse, hole, or periodic-results in distinct spreading behaviors. By obtaining the fundamental solution, we also discuss the influence of surface diffusion. We identify situations where spreading can be described as an effective diffusion process but observe that this approximation is not generally valid. Finally, the case of a three-dimensional flow with axial symmetry is briefly considered. Our findings should provide reference solutions for Marangoni spreading that may be tested experimentally with fluorescent or photoswitchable surfactants.

Download full-text PDF

Source
http://dx.doi.org/10.1103/PhysRevE.106.045107DOI Listing

Publication Analysis

Top Keywords

marangoni spreading
12
exact solutions
8
spreading
7
solutions viscous
4
marangoni
4
viscous marangoni
4
spreading surface-active
4
surface-active molecules
4
molecules released
4
released liquid
4

Similar Publications

Despite its important technological applications, surfactant-enhanced (spontaneous) spreading on a solid surface and how to optimize it on surfaces with different wettabilities are not well understood. Spontaneous spreading involves a surface tension gradient (Marangoni stresses), which enhances spreading over a large area. Experimental observations reveal that the spreading rate and surfactant concentration have an optimum substrate wettability of 60 ± 5° (Hill, R.

View Article and Find Full Text PDF

Transferable Percolated Particle Monolayers Derived from Marangoni Flows for Thermally Conductive Dielectric Coatings.

ACS Appl Mater Interfaces

November 2024

Department of Mechanical and Industrial Engineering, Northeastern University, Boston, Massachusetts 02115, United States.

Thermal management is becoming one of the most significant design and size limitations for high power density electronics, including motherboards, power converters, and phased array antennas for 5G communications. There are few options for conducting heat away with dielectric materials that avoid shortening or distorting the performance of these electronics. Certain highly thermally conductive 2D and 3D materials, including hexagonal boron nitride and diamond, offer ideal material properties to address these issues but are extremely challenging to process.

View Article and Find Full Text PDF

Adsorption, Adhesion, and Wettability of Commercially Available Cleansers at Dental Polymer (PMMA) Surfaces.

Materials (Basel)

September 2024

Institute of Experimental Physics, Faculty of Mathematics, Physics and Informatics, University of Gdańsk, Wita Stwosza 57, 80-308 Gdańsk, Poland.

This study aims to evaluate the adsorptive, adhesive, and wetting energetic properties of five commercially available cleansers in contact with model dental polymer (PMMA). It was assumed that the selected parameters allow for determining the optimal concentration and place of key component accumulation for antibacterial activity in the bulk liquid phase and prevention of oral plaque formation at the prosthetic material surface. The adsorptive (Gibbs' excesses , critical micellar concentration) and thermal (entropy and enthalpy) surface characteristics originated from surface tension and dependences.

View Article and Find Full Text PDF

A surfactant's equilibrium spreading pressure (ESP) is the maximum decrease in surface tension achievable at equilibrium below the Krafft point. Difficulties in measuring the ESP have been noted previously but no well-established experimental protocols to overcome them exist. We present a case study of three solid amphiphiles with different propensities to spread on the air-water interface.

View Article and Find Full Text PDF
Article Synopsis
  • Mocha diffusion is an important but poorly understood phenomenon in pottery painting that involves the spreading of ethanol droplets on acrylic paint.
  • The study found that as the concentration of ethanol increases, the spreading radius of the droplets expands, while the fractal period decreases, suggesting a unique pattern formation.
  • Marangoni flow, caused by the evaporation of ethanol, plays a key role in developing the intricate "dendrite" shapes during this process, emphasizing the need for further research into the dynamics of Mocha diffusion.
View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!